High pressure fluid in a shell and tube heat exchanger should preferably be routed through the?

Tubes to avoid the expansion of high pressure shell construction
Shell side for smaller total pressure drop
Shell side, if the flow is counter-current and tube side if the flow is co-current
Shell side for large overall heat transfer co-efficient

LohaHridoy

4 views

2025-01-04 04:42

1 Answers

AhmedNazir

Answer: Option 1

4 views Answered 2022-09-01 13:21

Related Questions

A heat exchanger with heat transfer surface area A and overall heat transfer coefficient U handles two fluids of heat capacities Cmax and Cmin. The number of transfer units (NTU) used in the analysis of heat exchanger is specified as?

1 Answers 7 Views

In a shell and tube heat exchanger, putting a longitudinal baffle across the shell, forces the shell side fluid to pass __________ through the heat exchanger.?

1 Answers 4 Views

In a shell and tube heat exchanger, the tube side heat transfer co-efficient just at the entrance of the tube is?

1 Answers 5 Views

Extremely large or small volumes of fluids are generally best routed through the shell side of a shell and tube heat exchanger, because of the?

1 Answers 5 Views

A concentric double pipe heat exchanger as compared to the shell and tube heat exchanger for the same heat load requires?

1 Answers 4 Views

For the same heat load and mass flow rate in the tube side of a shell and tube heat exchanger, one may use multipass on the tube side, because it?

1 Answers 18 Views

Air is to be heated by condensing steam. Two heat exchangers are available (i) a shell and tube heat exchanger and (ii) a finned tube heat exchanger. Tube side heat transfer area are equal in both the cases. The recommended arrangement is?

1 Answers 5 Views

Ratio of tube length to shell diameter for a shell and tube heat exchanger is?

1 Answers 4 Views

In a multipass shell and tube heat exchanger, the problem of differential expansion between the shell and tube passes is taken care of by using a?

1 Answers 6 Views

In case of a shell and tube heat exchanger, the minimum shell thickness for carbon steel (inclusive of corrosion allowance) depends on shell diameter and is in the range of __________ mm.?

1 Answers 5 Views

এক্সাম দিয়ে মেধা যাচাই করুন

Job Preparation (1125)

Admission (754)

এসএসসি (10)

এইচএসসি (5)