In case of a shell and tube heat exchanger, the minimum shell thickness for carbon steel (inclusive of corrosion allowance) depends on shell diameter and is in the range of __________ mm.?

3-5
5-11
8-15
12-18

LohaHridoy

5 views

2025-01-04 04:42

1 Answers

AhmedNazir

Answer: Option 2

5 views Answered 2022-09-01 13:21

Related Questions

In a shell and tube heat exchanger, putting a longitudinal baffle across the shell, forces the shell side fluid to pass __________ through the heat exchanger.?

1 Answers 4 Views

In case of a multipass shell and tube heat exchanger, providing a baffle on the shell side __________ the heat transfer rate.?

1 Answers 8 Views

In a shell and tube heat exchanger, the tube side heat transfer co-efficient just at the entrance of the tube is?

1 Answers 5 Views

A concentric double pipe heat exchanger as compared to the shell and tube heat exchanger for the same heat load requires?

1 Answers 4 Views

For the same heat load and mass flow rate in the tube side of a shell and tube heat exchanger, one may use multipass on the tube side, because it?

1 Answers 18 Views

Air is to be heated by condensing steam. Two heat exchangers are available (i) a shell and tube heat exchanger and (ii) a finned tube heat exchanger. Tube side heat transfer area are equal in both the cases. The recommended arrangement is?

1 Answers 5 Views

Minimum tube pitch recommended for shell and tube heat exchangers is about __________ times the outside diameter of the tube.?

1 Answers 6 Views

In the design of a shell and tube heat exchanger, the corrosion allowance?

1 Answers 5 Views

The ratio of tube length to shell diameter in case of liquid shell and tube heat exchanger ranges from?

1 Answers 7 Views

In a shell and tube heat exchanger for a given heat transfer surface area, smaller diameter tubes are favoured as compared to larger diameter ones ; because the smaller diameter tubes?

1 Answers 6 Views

এক্সাম দিয়ে মেধা যাচাই করুন

Job Preparation (1125)

Admission (754)

এসএসসি (10)

এইচএসসি (5)