Extremely large or small volumes of fluids are generally best routed through the shell side of a shell and tube heat exchanger, because of the?

Less corrosion problems
Flexibility possible in the baffle arrangement
Low pressure drop
High heat transfer co-efficient

LohaHridoy

5 views

2025-01-04 04:42

1 Answers

AhmedNazir

Answer: Option 2

5 views Answered 2022-09-01 13:21

Related Questions

A heat exchanger with heat transfer surface area A and overall heat transfer coefficient U handles two fluids of heat capacities Cmax and Cmin. The number of transfer units (NTU) used in the analysis of heat exchanger is specified as?

1 Answers 7 Views

In a shell and tube heat exchanger, putting a longitudinal baffle across the shell, forces the shell side fluid to pass __________ through the heat exchanger.?

1 Answers 4 Views

In case of a multipass shell and tube heat exchanger, providing a baffle on the shell side __________ the heat transfer rate.?

1 Answers 8 Views

For large heat transfer area requirement, shell and tube heat exchanger is preferred, because it?

1 Answers 7 Views

In a shell and tube heat exchanger, the tube side heat transfer co-efficient just at the entrance of the tube is?

1 Answers 5 Views

A concentric double pipe heat exchanger as compared to the shell and tube heat exchanger for the same heat load requires?

1 Answers 4 Views

For the same heat load and mass flow rate in the tube side of a shell and tube heat exchanger, one may use multipass on the tube side, because it?

1 Answers 18 Views

Air is to be heated by condensing steam. Two heat exchangers are available (i) a shell and tube heat exchanger and (ii) a finned tube heat exchanger. Tube side heat transfer area are equal in both the cases. The recommended arrangement is?

1 Answers 5 Views

High pressure fluid in a shell and tube heat exchanger should preferably be routed through the?

1 Answers 4 Views

In case of a shell and tube heat exchanger, the minimum shell thickness for carbon steel (inclusive of corrosion allowance) depends on shell diameter and is in the range of __________ mm.?

1 Answers 5 Views

এক্সাম দিয়ে মেধা যাচাই করুন

Job Preparation (1125)

Admission (754)

এসএসসি (10)

এইচএসসি (5)