If the length of a wall on either side of a lintel opening is at least half of its effective span L, the load W carried by the lintel is equivalent to the weight of brickwork contained in an equilateral triangle, producing a maximum bending moment?

WL/2
WL/4
WL/6
WL/8

LohaHridoy

11 views

2025-01-04 04:42

1 Answers

AhmedNazir

Answer: Option 3

11 views Answered 2022-09-01 13:21

Related Questions

Sinking of an intermediate support of a continuous beami) reduces the negative moment at supportii) increases the negative moment at supportiii) reduces the positive moment at center of spaniv) increases the positive moment at center of span The correct answer is?

1 Answers 4 Views

In a ring beam subjected to uniformly distributed loadi) shear force at mid span is zeroii) shear force at mid span is maximumiii) torsion at mid span is zeroiv) torsion at mid span is maximum The correct answer is?

1 Answers 6 Views

The bending moment ‘M’ and a torque ‘T’ is applied on a solid circular shaft. If the maximum bending stress equals to maximum shear stress developed, then ‘M’ is equal to?

1 Answers 5 Views

The bending moment at a section tends to bend or deflect the beam and the internal stresses resist its bending. The resistance offered by the internal stresses, to the bending, is called?

1 Answers 5 Views

The maximum bending moment of a simply supported beam of span $$l$$ and carrying a point load W at the center of beam, is?

1 Answers 4 Views

A shaft of diameter D is subjected to a twisting moment (T) and a bending moment (M). If the maximum bending stress is equal to maximum shear stress developed, then M is equal to?

1 Answers 4 Views

A simply supported beam A carries a point load at its mid span. Another identical beam B carries the same load but uniformly distributed over the entire span. The ratio of the maximum deflections of the beams A and B, will be?

1 Answers 4 Views

If W is total load per unit area on a panel, D is the diameter of the column head, L is the span in two directions, then the sum of the maximum positive bending moment and average of the negative bending moment for the design of the span of a square flat slab, should not be less than?

1 Answers 5 Views

If K is a constant depending upon the ratio of the width of the slab to its effective span l, x is the distance of the concentrated load from the nearer support, bw is the width of the area of contact of the concentrated load measured parallel to the supported edge, the effective width of the slab be is?

1 Answers 5 Views

To ensure that the hogging bending moment at two points of suspension of a pile of length L equals the sagging moment at its centre, the distances of the points of suspension from either end, is?

1 Answers 6 Views

এক্সাম দিয়ে মেধা যাচাই করুন

Job Preparation (1125)

Admission (754)

এসএসসি (10)

এইচএসসি (5)