In testing a pile by load test, pile platform is loaded with one and half times the design load and a maximum settlement is noted. The load is gradually removed and the consequent rebound is measured. For a safe pile, the net settlement (i.e. total settlement minus rebound) per tonne of test load should not exceed?

10 mm
15 mm
20 mm
25 mm

LohaHridoy

5 views

2025-01-04 04:42

1 Answers

AhmedNazir

Answer: Option 4

5 views Answered 2022-09-01 13:21

Related Questions

A thin mild steel wire is loaded by adding loads in equal increments till it breaks. The extensions noted with increasing loads will behave as under?

1 Answers 5 Views

The simply supported beam 'A' of length '$$l$$' carries a central point load 'W'. Another beam 'B' is loaded with a uniformly distributed load such that the total load on the beam is 'W'. The ratio of maximum deflections between beams 'A' and 'B' is?

1 Answers 5 Views

The ratio of the stresses produced by a suddenly applied load and by a gradually applied load on a bar, is?

1 Answers 4 Views

In a pre-stressed beam carrying an external load W with a bent tendon is having angle of inclination and pre-stressed load P. The net downward load at the centre is?

1 Answers 5 Views

If W is total load per unit area on a panel, D is the diameter of the column head, L is the span in two directions, then the sum of the maximum positive bending moment and average of the negative bending moment for the design of the span of a square flat slab, should not be less than?

1 Answers 5 Views

A pile of length ‘L’ carrying a uniformly distributed load ‘W’ per metre length is suspended at two points, the maximum, B.M. at the centre of the pile or at the points of suspension, is?

1 Answers 5 Views

The differential settlement in case of foundations on sandy soils should not exceed?

1 Answers 4 Views

Threshold Limit Value (TLV) is the maximum allowable concentration (i.e. safe limit) of pollutants in air. Safe limit for SO₂ in air is __________ ppm.?

1 Answers 5 Views

The testing pressure of storage tanks and pressure vessels designed as per Indian standard codes should be about __________ times.the design pressure.?

1 Answers 4 Views

In case of saddle packing (e.g., berl and intralox saddles), the maximum size of the packing should not exceed __________ of the column diameter.?

1 Answers 6 Views

এক্সাম দিয়ে মেধা যাচাই করুন

Job Preparation (1125)

Admission (754)

এসএসসি (10)

এইচএসসি (5)