If a bent tendon is required to balance a concentrated load W at the centre of the span L, the central dip h must be at least?

WL/P
WL/2P
WL/3P
WL/4P

LohaHridoy

6 views

2025-01-04 04:42

1 Answers

AhmedNazir

Answer: Option 4

6 views Answered 2022-09-01 13:21

Related Questions

In a ring beam subjected to uniformly distributed loadi) shear force at mid span is zeroii) shear force at mid span is maximumiii) torsion at mid span is zeroiv) torsion at mid span is maximum The correct answer is?

1 Answers 6 Views

A simply supported beam A carries a point load at its mid span. Another identical beam B carries the same load but uniformly distributed over the entire span. The ratio of the maximum deflections of the beams A and B, will be?

1 Answers 4 Views

If a three hinged parabolic arch, (span l, rise h) is carrying a uniformly distributed load w/unit length over the entire span,?

1 Answers 7 Views

The maximum deflection of a simply supported beam of span L, carrying an isolated load at the centre of the span; flexural rigidity being EI, is?

1 Answers 5 Views

In a pre-stressed beam carrying an external load W with a bent tendon is having angle of inclination and pre-stressed load P. The net downward load at the centre is?

1 Answers 5 Views

If the tendon is placed at an eccentricity e below the centroidal axis of the longitudinal axis of a rectangular beam (sectional modulus Z and stressed load P in tendon) the stress at the extreme top edge?

1 Answers 6 Views

If W is total load per unit area on a panel, D is the diameter of the column head, L is the span in two directions, then the sum of the maximum positive bending moment and average of the negative bending moment for the design of the span of a square flat slab, should not be less than?

1 Answers 5 Views

If the maximum dip of a parabolic tendon carrying tension P is h and the effective length of the pre-stressed beam is L, the upward uniform pressure will be?

1 Answers 4 Views

If K is a constant depending upon the ratio of the width of the slab to its effective span l, x is the distance of the concentrated load from the nearer support, bw is the width of the area of contact of the concentrated load measured parallel to the supported edge, the effective width of the slab be is?

1 Answers 5 Views

In testing a pile by load test, pile platform is loaded with one and half times the design load and a maximum settlement is noted. The load is gradually removed and the consequent rebound is measured. For a safe pile, the net settlement (i.e. total settlement minus rebound) per tonne of test load should not exceed?

1 Answers 5 Views

এক্সাম দিয়ে মেধা যাচাই করুন

Job Preparation (1125)

Admission (754)

এসএসসি (10)

এইচএসসি (5)