The bending moment at a point on a beam is the algebraic ________ of all the moments on either side of the point.?

Sum
Difference
Multiplication
None of the above

LohaHridoy

4 views

2025-01-04 04:42

1 Answers

AhmedNazir

Answer: Option 1

4 views Answered 2022-09-01 13:21

Related Questions

A simply supported beam 'A' of length l, breadth b, and depth d carries a central point load W. Another beam 'B' has the same length and depth but its breadth is doubled. The deflection of beam 'B' will be __________ as compared to beam 'A'.?

1 Answers 7 Views

The bending moment at a section tends to bend or deflect the beam and the internal stresses resist its bending. The resistance offered by the internal stresses, to the bending, is called?

1 Answers 5 Views

The maximum bending moment of a simply supported beam of span $$l$$ and carrying a point load W at the center of beam, is?

1 Answers 4 Views

A shaft of diameter D is subjected to a twisting moment (T) and a bending moment (M). If the maximum bending stress is equal to maximum shear stress developed, then M is equal to?

1 Answers 4 Views

The shear force at a point on a beam is the algebraic __________ of all the forces on either side of the point.?

1 Answers 5 Views

If a number of coplanar forces acting at a point be in equilibrium, the sum of clockwise moments must be __________ the sum of anticlockwise moments, about any point.?

1 Answers 5 Views

H V are the algebraic sums of the forces resolved horizontally and vertically respectively, M is the algebraic sum of the moments of forces about any point, for the equilibrium of the body acted upon?

1 Answers 5 Views

A simply supported beam carries varying load from zero at one end and w at the other end. If the length of the beam is a, the maximum bending moment will be?

1 Answers 6 Views

Bending moment at any section in a conjugate beam gives in the actual beam?

1 Answers 5 Views

If W is total load per unit area on a panel, D is the diameter of the column head, L is the span in two directions, then the sum of the maximum positive bending moment and average of the negative bending moment for the design of the span of a square flat slab, should not be less than?

1 Answers 5 Views

এক্সাম দিয়ে মেধা যাচাই করুন

Job Preparation (1125)

Admission (754)

এসএসসি (10)

এইচএসসি (5)