Bending moment at any section in a conjugate beam gives in the actual beam?

slope
curvature
deflection
bending moment

LohaHridoy

5 views

2025-01-04 04:42

1 Answers

AhmedNazir

Answer: Option 3

5 views Answered 2022-09-01 13:21

Related Questions

Sinking of an intermediate support of a continuous beami) reduces the negative moment at supportii) increases the negative moment at supportiii) reduces the positive moment at center of spaniv) increases the positive moment at center of span The correct answer is?

1 Answers 4 Views

If the section modulus of a beam is increased, the bending stress in the beam will?

1 Answers 6 Views

The bending moment at a section tends to bend or deflect the beam and the internal stresses resist its bending. The resistance offered by the internal stresses, to the bending, is called?

1 Answers 5 Views

The maximum bending moment of a simply supported beam of span $$l$$ and carrying a point load W at the center of beam, is?

1 Answers 4 Views

A shaft of diameter D is subjected to a twisting moment (T) and a bending moment (M). If the maximum bending stress is equal to maximum shear stress developed, then M is equal to?

1 Answers 4 Views

In a simple bending theory, one of the assumptions is that the plane sections before bending remain plane after bending. This assumption means that?

1 Answers 4 Views

Y are the bending moment, moment of inertia, radius of curvature, modulus of If M, I, R, E, F, and elasticity stress and the depth of the neutral axis at section, then?

1 Answers 6 Views

A simply supported beam carries varying load from zero at one end and w at the other end. If the length of the beam is a, the maximum bending moment will be?

1 Answers 6 Views

At any point of a beam, the section modulus may be obtained by dividing the moment of inertia of the section by?

1 Answers 4 Views

If W is total load per unit area on a panel, D is the diameter of the column head, L is the span in two directions, then the sum of the maximum positive bending moment and average of the negative bending moment for the design of the span of a square flat slab, should not be less than?

1 Answers 5 Views

এক্সাম দিয়ে মেধা যাচাই করুন

Job Preparation (1125)

Admission (754)

এসএসসি (10)

এইচএসসি (5)