The lead screw of a lathe with nut forms a?

Rolling pair
Sliding pair
Screw pair
Turning pair

LohaHridoy

4 views

2025-01-04 04:42

1 Answers

AhmedNazir

Answer: Option 3

4 views Answered 2022-09-01 13:21

Related Questions

The lead screw of a lathe has _________ threads.?

1 Answers 6 Views

A feed gear box for a screw cutting lathe is designed on the basis of?

1 Answers 6 Views

In a center lathe, the cutting tool is fed in _________ with reference to the lathe axis.?

1 Answers 4 Views

A lead-screw with half nuts in a lathe, free to rotate in both directions has?

1 Answers 5 Views

For standard coarse threads of nut, the threads will be as strong in failure by shear as the bolt in tension, if the height of nut (h) is approximately?

1 Answers 5 Views

While designing a screw in a screw jack against buckling failure, the end conditions for the screw are taken as?

1 Answers 6 Views

If shearing stress in nut is half the tensile stress in a bolt, then nut length should be equal to?

1 Answers 5 Views

A screw is said to be over hauling screw, if the?

1 Answers 5 Views

A screw is said to be over hauling screw, if its efficiency is?

1 Answers 5 Views

The pitch of threads on a Jock nut in comparison to pitch of nut is?

1 Answers 4 Views

এক্সাম দিয়ে মেধা যাচাই করুন

Job Preparation (1125)

Admission (754)

এসএসসি (10)

এইচএসসি (5)