For standard coarse threads of nut, the threads will be as strong in failure by shear as the bolt in tension, if the height of nut (h) is approximately?

0.4 times
0.6 times
0.7 times
0.8 times

LohaHridoy

5 views

2025-01-04 04:42

1 Answers

AhmedNazir

Answer: Option 1

5 views Answered 2022-09-01 13:21

Related Questions

If d is the normal diameter of a bolt in mm, then the initial tension in kg in a bolt used for making a fluid tight joint as for steam engine cover joint is calculated by the relation?

1 Answers 4 Views

The following type of nut is used with alien bolt?

1 Answers 4 Views

If threads on a bolt are left hand, threads on nut will be?

1 Answers 5 Views

If shearing stress in nut is half the tensile stress in a bolt, then nut length should be equal to?

1 Answers 5 Views

The pitch of threads on a Jock nut in comparison to pitch of nut is?

1 Answers 4 Views

The tension on the slack side of the belt is __________ the tension on the tight side of the belt.?

1 Answers 4 Views

A bolt is made to pass through a tube and both of them are tightly fitted with the help of washers and nuts. If the nut is tightened, then?

1 Answers 4 Views

The length of lap in tension reinforcement should not be less than the bar diameter × (actual tension / four times the permissible average bond stress) if it is more than?

1 Answers 5 Views

Square steel key is normally strong in failure by shear & crushing. Keys are normally made of __________ steel bars.?

1 Answers 5 Views

Failure of a material is termed as fatigue failure, if it fails below the yield point. The resistance to fatigue failure of a material is measured by the?

1 Answers 5 Views

এক্সাম দিয়ে মেধা যাচাই করুন

Job Preparation (1125)

Admission (754)

এসএসসি (10)

এইচএসসি (5)