Bissoy.com
Login
Doctors
Medicines
MCQs
Q&A
Ask
Merit Test
Questions
Courses
A bolt is made to pass through a tube and both of them are tightly fitted with the help of washers and nuts. If the nut is tightened, then?
Bolt and tube are under tension
Bolt and tube are under compression
Bolt is under compression and tube is under tension
Bolt is under tension and tube is under compression
LohaHridoy
0
Edit
4
views
2025-01-04 04:42
1
Answers
AhmedNazir
Answer: Option 4
0
Thanks
4
views
Answered
2022-09-01 13:21
Report
Edit
Call
Related Questions
For standard coarse threads of nut, the threads will be as strong in failure by shear as the bolt in tension, if the height of nut (h) is approximately?
1 Answers
5
Views
If d is the normal diameter of a bolt in mm, then the initial tension in kg in a bolt used for making a fluid tight joint as for steam engine cover joint is calculated by the relation?
1 Answers
4
Views
The following type of nut is used with alien bolt?
1 Answers
4
Views
If shearing stress in nut is half the tensile stress in a bolt, then nut length should be equal to?
1 Answers
5
Views
The pitch of threads on a Jock nut in comparison to pitch of nut is?
1 Answers
4
Views
A rod is enclosed centrally in a tube and the assembly is tightened by rigid washers. If the assembly is subjected to a compressive load, then?
1 Answers
5
Views
The most important function of a washer is to provide bearing area and washers are normally specified by their hole diameters. The diameter of washer as compared to the nut is?
1 Answers
4
Views
If all the conditions and dimensions are same, then the ratio of velocity through the tubes of a double pass heat exchanger to that through the single pass heat exchanger is?
1 Answers
4
Views
If a single tube pass heat exchanger is converted to two pass, then for the same flow rate, the pressure drop per unit length in tube side will?
1 Answers
5
Views
Air is to be heated by condensing steam. Two heat exchangers are available (i) a shell and tube heat exchanger and (ii) a finned tube heat exchanger. Tube side heat transfer area are equal in both the cases. The recommended arrangement is?
1 Answers
5
Views
কোরআন
হাদিস
চাকুরি প্রস্তুতি
বিশ্ববিদ্যালয় ভর্তি
মেডিকেল SBA
12
এইচএসসি
10
এসএসসি
8
জেএসসি
এক্সাম দিয়ে মেধা যাচাই করুন
Job Preparation (1125)
Admission (754)
এসএসসি (10)
এইচএসসি (5)
Login Required
You need to log in to continue.
Login
Cancel
Download Required
You need to download the app to make a call.
Download
Cancel