A feed gear box for a screw cutting lathe is designed on the basis of?

Geometric progression
Arithmetic progression
Harmonic progression
None of these

LohaHridoy

6 views

2025-01-04 04:42

1 Answers

AhmedNazir

Answer: Option 1

6 views Answered 2022-09-01 13:21

Related Questions

The lead screw of a lathe has _________ threads.?

1 Answers 6 Views

While cutting helical gears on a non-differential gear hobber, the feed change gear ratio is?

1 Answers 6 Views

In a center lathe, the cutting tool is fed in _________ with reference to the lathe axis.?

1 Answers 4 Views

A lead-screw with half nuts in a lathe, free to rotate in both directions has?

1 Answers 5 Views

In an orthogonal cutting, the depth of cut is halved and the feed rate is double. If the chip thickness ratio is unaffected with the changed cutting conditions, the actual chip thickness will be?

1 Answers 5 Views

In counterfort type retaining wallsi) the vertical slab is designed as a continuous slabii) the heel slab is designed as a continuous slabiii) the vertical slab is designed as a cantileveriv) the heel slab is designed as a cantileverThe correct answer is?

1 Answers 6 Views

The lead screw of a lathe with nut forms a?

1 Answers 4 Views

While designing a screw in a screw jack against buckling failure, the end conditions for the screw are taken as?

1 Answers 6 Views

A screw is said to be over hauling screw, if the?

1 Answers 5 Views

A screw is said to be over hauling screw, if its efficiency is?

1 Answers 5 Views

এক্সাম দিয়ে মেধা যাচাই করুন

Job Preparation (1125)

Admission (754)

এসএসসি (10)

এইচএসসি (5)