To prevent a DC return between source and load, it is necessary to use?

Resistor between source and load
Inductor between source and load
Capacitor between source and load
Either A or B

LohaHridoy

4 views

2025-01-04 04:42

1 Answers

AhmedNazir

Answer: Option 3

4 views Answered 2022-09-01 13:21

Related Questions

This mention statement is associated with “Any number of current sources in parallel may be replaced by a single current source whose current is the algebraic sum of individual currents and source resistance is the parallel combination of individual source resistances”.?

1 Answers 9 Views

The load factors for live load and dead load are taken respectively as?

1 Answers 6 Views

Assertion A : The load factor for live load is greater than that for dead load.Reason R : The live loads are more uncertain than dead loads.Select your answer based on the coding system given below :?

1 Answers 6 Views

In order to get maximum power transfer from a capacitive source, the load must have an impedance that is the complex conjugate of the source impedance.?

1 Answers 4 Views

In a single stage transistor amplifier, RC and RL represent collector resistance and load resistance respectively. The transistor sees a d.c. load of ___________?

1 Answers 5 Views

If RC and RL represent the collector resistance and load resistance respectively in a single stage transistor amplifier, then a.c. load is?

1 Answers 51 Views

The simply supported beam 'A' of length '$$l$$' carries a central point load 'W'. Another beam 'B' is loaded with a uniformly distributed load such that the total load on the beam is 'W'. The ratio of maximum deflections between beams 'A' and 'B' is?

1 Answers 5 Views

The ratio of the maximum deflections of a simply supported beam with a central load W and of a cantilever of same length and with a load W at its free end, is?

1 Answers 5 Views

In a pre-stressed beam carrying an external load W with a bent tendon is having angle of inclination and pre-stressed load P. The net downward load at the centre is?

1 Answers 5 Views

In testing a pile by load test, pile platform is loaded with one and half times the design load and a maximum settlement is noted. The load is gradually removed and the consequent rebound is measured. For a safe pile, the net settlement (i.e. total settlement minus rebound) per tonne of test load should not exceed?

1 Answers 5 Views

এক্সাম দিয়ে মেধা যাচাই করুন

Job Preparation (1125)

Admission (754)

এসএসসি (10)

এইচএসসি (5)