Which command would you use to apply an access list to a router interface?

ip access-list 101 out
access-list ip 101 in
ip access-group 101 in
access-group ip 101 in

LohaHridoy

4 views

2025-01-04 04:42

1 Answers

AhmedNazir

Answer: Option 3

To apply an access list, the proper command is ip access-group 101 in.

4 views Answered 2022-09-01 13:21

Related Questions

You save the configuration on a router with the copy running-config startup-config command and reboot the router. The router, however, comes up with a blank configuration. What can the problem be?

1 Answers 5 Views

You need to find the broadcast address used on a LAN on your router. What command will you type into the router from user mode to find the broadcast address?

1 Answers 4 Views

You want to totally reinitialize the router and replace the current running-config with the current startup-config. What command will you use?

1 Answers 5 Views

What router command allows you to determine whether an IP access list is enabled on a particular interface?

1 Answers 7 Views

The corporate office sends you a new router to connect, but upon connecting the console cable, you see that there is already a configuration on the router. What should be done before a new configuration is entered in the router?

1 Answers 5 Views

If routers in a single area are configured with the same priority value, what value does a router use for the OSPF Router ID in the absence of a loopback interface?

1 Answers 9 Views

You are adding a new server to your network. The network uses TCP/IP. The new server will provide users with dial-up access to network resources. The data link communications protocol you choose for dial-up access must allow you to provide secure authentication. Which protocol should you choose?

1 Answers 4 Views

Which command is used to determine if an IP access list is enabled on a particular interface?

1 Answers 7 Views

Which router command allows you to view the entire contents of all access lists?

1 Answers 4 Views

You need to configure a router for a Frame Relay connection to a non-Cisco router. Which of the following commands will prepare the WAN interface of the router for this connection?

1 Answers 5 Views

এক্সাম দিয়ে মেধা যাচাই করুন

Job Preparation (1125)

Admission (754)

এসএসসি (10)

এইচএসসি (5)