Which of the following parameters of the fluid is not very important, while deciding its route in a shell and tube heat exchanger?

Corrosiveness & fouling characteristics
Pressure
Viscosity
Density

LohaHridoy

5 views

2025-01-04 04:42

1 Answers

AhmedNazir

Answer: Option 4

Let'

5 views Answered 2022-09-01 13:21

Related Questions

__________ heat exchanger is the most suitable, when the temperature of shell side fluid is much higher than that of tube side.?

1 Answers 5 Views

In case of a shell and tube heat exchanger, the minimum and maximum baffle spacing is respectively (where, D = inside diameter of the shell)?

1 Answers 7 Views

Minimum recommended baffle spacing in a shell and tube heat exchanger is about (where, D = shell diameter)?

1 Answers 6 Views

In a shell and tube heat exchanger having square pitch, the shell side equivalent diameter is given by (where, P = pitch, d = outside diameter of the tube)?

1 Answers 7 Views

Minimum recommended baffle spacing in a shell and tube heat exchanger is about (where, D = shell diameter )?

1 Answers 4 Views

Which is the best tube arrangement (in a shell and tube heat exchanger) if the fluids are clean and non-fouling?

1 Answers 5 Views

Which of the following parameters is increased by use of finned tube in a multipass shell and tube heat exchanger?

1 Answers 5 Views

Which characteristic of a fluid is not important in deciding its route in a shell and tube heat exchanger?

1 Answers 6 Views

LMTD correction factor which is to be applied for a cross-flow heat exchanger increases with increase in the number of shell passes. Its value for a single pass cross flow heat exchanger is?

1 Answers 6 Views

Baffles are provided in a shell and tube heat exchanger to increase the turbulence and velocity of the shell side fluid. Which of the following shaped baffles does not fall in the category of transverse baffle?

1 Answers 5 Views

এক্সাম দিয়ে মেধা যাচাই করুন

Job Preparation (1125)

Admission (754)

এসএসসি (10)

এইচএসসি (5)