- Square pitch
- Triangular pitch
- Diagonal square pitch
- None of these
1 Answers
Call
Talk Doctor Online in Bissoy App
Fourier's law of heat conduction is (where Q = Amount of heat flow through the body in unit time, A = Surface area of heat flow, taken at right angles to the direction of heat flow, dT = Temperature difference on the two faces of the body, dx = Thickness of the body, through which the heat flows, taken along the direction of heat flow, and k = Thermal conductivity of the body)?
Answer: Option 1 Fourier's law of heat conduction is k. A. (dT/dx) where Q = Amount of heat flow through the body in unit time, A = Surface area of heat...
1 Answers 1 views
In case of a shell and tube heat exchanger, the minimum and maximum baffle spacing is respectively (where, D = inside diameter of the shell)?
Answer: Option 1 Let'
1 Answers 2 views
Fouling factor for a heat exchanger is given by (where, U₁ = heat transfer co-efficient of dirty surface U₂ = heat transfer co-efficient of clean surface)?
Answer: Option 2 Let'
1 Answers 1 views
Minimum recommended baffle spacing in a shell and tube heat exchanger is about (where, D = shell diameter)?
Answer: Option 1 Let'
1 Answers 1 views
In a shell and tube heat exchanger having square pitch, the shell side equivalent diameter is given by (where, P = pitch, d = outside diameter of the tube)?
Answer: Option 1 Let'
1 Answers 4 views
Minimum recommended baffle spacing in a shell and tube heat exchanger is about (where, D = shell diameter )?
Answer: Option 1 Let'
1 Answers 1 views
Which of the following parameters is increased by use of finned tube in a multipass shell and tube heat exchanger?
Answer: Option 4 Let'
1 Answers 1 views
LMTD correction factor which is to be applied for a cross-flow heat exchanger increases with increase in the number of shell passes. Its value for a single pass cross flow heat exchanger is?
Answer: Option 4 Let'
1 Answers 3 views
Baffles are provided in a shell and tube heat exchanger to increase the turbulence and velocity of the shell side fluid. Which of the following shaped baffles does not fall in the category of transverse baffle?
Answer: Option 2 Let'
1 Answers 1 views
Which tube arrangement in a heat exchanger would facilitate highest heat transfer rate?
Answer: Option 1 Let'
1 Answers 1 views