Fouling factor for a heat exchanger is given by (where, U₁ = heat transfer co-efficient of dirty surface U₂ = heat transfer co-efficient of clean surface)?

U₁ - U₂
1/U₁ - 1/U₂
1/U₂ - 1/U₁
U₂ - U₁

LohaHridoy

7 views

2025-01-04 04:42

1 Answers

AhmedNazir

Answer: Option 2

Let'

7 views Answered 2022-09-01 13:21

Related Questions

Fouling factor must be included in the calculation of over all design heat transfer coefficient, when the liquid?

1 Answers 6 Views

Sensible heat factor is given by (where S.H. = Sensible heat, and L.H. = Latent heat)?

1 Answers 7 Views

Fourier's law of heat conduction is (where Q = Amount of heat flow through the body in unit time, A = Surface area of heat flow, taken at right angles to the direction of heat flow, dT = Temperature difference on the two faces of the body, dx = Thickness of the body, through which the heat flows, taken along the direction of heat flow, and k = Thermal conductivity of the body)?

1 Answers 4 Views

The depth of centre of pressure (h) for a vertically immersed surface from the liquid surface is given by (where IG = Moment of inertia of the immersed surface about horizontal axis through its centre of gravity, A = Area of immersed surface, and x = Depth of centre of gravity of the immersed surface from the liquid surface)?

1 Answers 4 Views

The average heat transfer co-efficient for laminar film condensation on vertical surface is inversely proportional to (where, ΔT = Temperature drop across condensate film )?

1 Answers 4 Views

In a double pipe concentric heat exchanger, the equivalent diameter of annulus for heat transfer would be (where, D₁ and D₂ are I.D. of inner and outer pipes)?

1 Answers 6 Views

Controlling heat transfer film co-efficient is the one, which offers __________ resistance to heat transfer.?

1 Answers 5 Views

Which is the best tube arrangement (in a shell and tube heat exchanger) if the fluids are clean and non-fouling?

1 Answers 5 Views

LMTD correction factor which is to be applied for a cross-flow heat exchanger increases with increase in the number of shell passes. Its value for a single pass cross flow heat exchanger is?

1 Answers 6 Views

Which tube arrangement in a heat exchanger would facilitate highest heat transfer rate?

1 Answers 5 Views

এক্সাম দিয়ে মেধা যাচাই করুন

Job Preparation (1125)

Admission (754)

এসএসসি (10)

এইচএসসি (5)