Which of the following parameters is increased by use of finned tube in a multipass shell and tube heat exchanger?

Tube side pressure drop and the heat transfer rate
Convective heat transfer co-efficient
Effective tube surface area for convective heat transfer
All of the above

LohaHridoy

5 views

2025-01-04 04:42

1 Answers

AhmedNazir

Answer: Option 4

Let'

5 views Answered 2022-09-01 13:21

Related Questions

Fourier's law of heat conduction is (where Q = Amount of heat flow through the body in unit time, A = Surface area of heat flow, taken at right angles to the direction of heat flow, dT = Temperature difference on the two faces of the body, dx = Thickness of the body, through which the heat flows, taken along the direction of heat flow, and k = Thermal conductivity of the body)?

1 Answers 4 Views

In case of a shell and tube heat exchanger, the minimum and maximum baffle spacing is respectively (where, D = inside diameter of the shell)?

1 Answers 7 Views

Minimum recommended baffle spacing in a shell and tube heat exchanger is about (where, D = shell diameter)?

1 Answers 6 Views

In a shell and tube heat exchanger having square pitch, the shell side equivalent diameter is given by (where, P = pitch, d = outside diameter of the tube)?

1 Answers 7 Views

Minimum recommended baffle spacing in a shell and tube heat exchanger is about (where, D = shell diameter )?

1 Answers 4 Views

Which is the best tube arrangement (in a shell and tube heat exchanger) if the fluids are clean and non-fouling?

1 Answers 5 Views

LMTD correction factor which is to be applied for a cross-flow heat exchanger increases with increase in the number of shell passes. Its value for a single pass cross flow heat exchanger is?

1 Answers 6 Views

Which of the following parameters of the fluid is not very important, while deciding its route in a shell and tube heat exchanger?

1 Answers 5 Views

Baffles are provided in a shell and tube heat exchanger to increase the turbulence and velocity of the shell side fluid. Which of the following shaped baffles does not fall in the category of transverse baffle?

1 Answers 5 Views

Which of the following is the most common type of baffle used in industrial shell and tube heat exchanger?

1 Answers 4 Views

এক্সাম দিয়ে মেধা যাচাই করুন

Job Preparation (1125)

Admission (754)

এসএসসি (10)

এইচএসসি (5)