The electrode tip diameter (d) in spot welding should be equal to (where t = Thickness of plate to be welded)?

√t
1.5 t
3 t
6 t

LohaHridoy

22 views

2025-01-04 04:42

1 Answers

AhmedNazir

Answer: Option 1

The electrode tip diameter (d) in spot welding should be equal to √t

22 views Answered 2022-09-01 13:21

Related Questions

When a hole of diameter ‘d’ is punched in a metal of thickness 't', then the force required to punch a hole is equal to (where $${\tau _{\text{u}}}$$ = Ultimate shear strength of the material of the plate)?

1 Answers 7 Views

Two plates of the same metal having equal thickness are to be butt welded with electric arc. When the plate thickness changes, welding is achieved by?

1 Answers 4 Views

A composite wall consists of two plates A and B placed in series normal to the flow of heat. The thermal conductivities are kA and kB and the specific heat capacities are CPA and CPB for plates A and B respectively. Plate B has twice the thickness of plate A. At steady state, the temperature difference across plate A is greater than that across plate B, when?

1 Answers 9 Views

If the flame of the welding torch is directed towards the progress of welding, then what will you call the welding technique?

1 Answers 4 Views

In order to avoid tearing of the plate at an edge, the distance from the centre line of the rivet hole to the nearest edge of the plate should be equal to (where d = Diameter of rivet hole)?

1 Answers 5 Views

The overlap of batten plates with the main members in welded connections should be more than (where t = thickness of the batten plate)?

1 Answers 28 Views

For flow over a flat plate, the ratio of thermal boundary layer thickness, 'xt' and hydrodynamic boundary layer thickness 'x' is equal to (where, NPr = Prandtl number)?

1 Answers 8 Views

In which type of welding a gas shield, a consumable electrode is used and the welding can be done in all positions.?

1 Answers 4 Views

Which among the NC operations given below are continuous path operationsArc Welding (AW), Drilling (D), Laser Cutting of Sheet Metal (LC), Milling (M), Punching in Sheet Metal (P), Spot Welding (SW)?

1 Answers 8 Views

The maximum thickness of the metal which can be welded using ultrasonic welding is __________ mm.?

1 Answers 4 Views

এক্সাম দিয়ে মেধা যাচাই করুন

Job Preparation (1125)

Admission (754)

এসএসসি (10)

এইচএসসি (5)