In order to avoid tearing of the plate at an edge, the distance from the centre line of the rivet hole to the nearest edge of the plate should be equal to (where d = Diameter of rivet hole)?

1 d
1.5 d
2.5 d
2 d

LohaHridoy

5 views

2025-01-04 04:42

1 Answers

AhmedNazir

Answer: Option 2

Let'

5 views Answered 2022-09-01 13:21

Related Questions

If there is a circular hole in a metal plate, what happens to the radius of the hole when the plate is heated?

1 Answers 5 Views

When a hole of diameter ‘d’ is punched in a metal of thickness 't', then the force required to punch a hole is equal to (where $${\tau _{\text{u}}}$$ = Ultimate shear strength of the material of the plate)?

1 Answers 7 Views

When the axis of load lies in the plane of rivet group, then the most heavily loaded rivet will be the one which (where, Fa is the load shared by each rivet due to axial load and Fm is the shearing load due to moment in any rivet.)?

1 Answers 10 Views

A composite wall consists of two plates A and B placed in series normal to the flow of heat. The thermal conductivities are kA and kB and the specific heat capacities are CPA and CPB for plates A and B respectively. Plate B has twice the thickness of plate A. At steady state, the temperature difference across plate A is greater than that across plate B, when?

1 Answers 9 Views

A metal plate with a circular hole at the centre is heated. What will happen to the area of the hole ?

1 Answers 5 Views

According to Unwin's formula, the relation between the diameter of rivet hole (d) and the thickness of plate (t) is given by (where d and t are in mm)?

1 Answers 5 Views

A plate with an elliptical hole in the centre, with semi-major axis (a) perpendicular to the direction of loading and semi-minor axis (b) along the direction of loading, is subjected to a pull P. The maximum stress induced at the edge of the hole is equal to (where $$\sigma $$ = Stress for a plate with no hole i.e. nominal stress)?

1 Answers 5 Views

Tearing resistance required to tear off the plate per pitch length is (where p = Pitch of rivets, d = Dia. of rivet hole and $${\sigma _{\text{t}}}$$ = Permissible tensile stress for plate material)?

1 Answers 6 Views

According to Unwin's formula, the relation between diameter of rivet hole (d) and thickness of plate (t) is given by (where d and t are in mm)?

1 Answers 7 Views

In order to avoid tearing off the plate at an edge, the distance from the center of the rivet hole to the nearest edge of the plate (i.e. margin) should be (where d = Diameter of rivet hole in mm)?

1 Answers 4 Views

এক্সাম দিয়ে মেধা যাচাই করুন

Job Preparation (1125)

Admission (754)

এসএসসি (10)

এইচএসসি (5)