The initial tension (in newtons) in a bolt used for making a fluid tight joint like steam engine cover joints, is calculated by the relation (where d = Nominal diameter of bolt in mm)?

1420 d
1680 d
2080 d
2840 d

LohaHridoy

6 views

2025-01-04 04:42

1 Answers

AhmedNazir

Answer: Option 4

Let'

6 views Answered 2022-09-01 13:21

Related Questions

When the belt is stationary, it is subjected to some tension known as initial tension. The value of this tension is equal to the?

1 Answers 5 Views

When the load on the engine increases, it becomes necessary to increase the supply of working fluid and when the load decreases, less working fluid is required. The supply of the working fluid to the engine is controlled by a?

1 Answers 4 Views

When a bolt and nut is made of mild steel, then the effective height of nut is made equal to (where d = Nominal diameter of bolt)?

1 Answers 32 Views

When two main plates are kept in alignment butting each other and riveted with cover plate on both sides of the main plates with two rows of rivets in each main plate, the joint is known as ________ double cover butt joint.?

1 Answers 4 Views

When the speed of the engine is controlled by means of a valve in a steam pipe, which regulates the pressure of steam entering the engine, then the governing is known as?

1 Answers 6 Views

When two main plates are kept in alignment butting each other and riveted with cover plate on both sides of the main plates with two rows of rivets in each main plate, the joint is known as _______ double cover butt joint.?

1 Answers 6 Views

A flanged pipe joint will be a leak-proof joint, if the circumferential pitch of the bolts is (where d = Diameter of bolt hole)?

1 Answers 5 Views

The brake power (B.P.) of the engine is given by (where W = Brake load or dead load in newtons, l = Length of arm in meters, N = Speed of engine in r.p.m., S = Spring balance reading in newtons, D = Dia. of brake drum in meters, and d = Dia. of rope in meters)?

1 Answers 14 Views

A steam turbine, in which a part of the steam after partial expansion, is used for process heating and the remaining steam is further expanded for power generation, is known as?

1 Answers 4 Views

Welded joint is superior to revetted joint in respect of ease of fabrication, weight and strength. Which of the following joints is the most suitable for pipes carrying fluids under high pressure and temperature?

1 Answers 4 Views

এক্সাম দিয়ে মেধা যাচাই করুন

Job Preparation (1125)

Admission (754)

এসএসসি (10)

এইচএসসি (5)