When a bolt and nut is made of mild steel, then the effective height of nut is made equal to (where d = Nominal diameter of bolt)?

0.5 d
0.75 d
d
1.25 d

LohaHridoy

32 views

2025-01-04 04:42

1 Answers

AhmedNazir

Answer: Option 3

Let'

32 views Answered 2022-09-01 13:21

Related Questions

When a bolt is subjected to an external load, the stress induced in the bolt will be?

1 Answers 7 Views

When a nut is tightened by placing a washer below it, the bolt will be subjected to following type of loads?

1 Answers 5 Views

When the connected members are very yielding (soft gasket) as compared to the bolt, then the resultant load on the bolt will be equal to the?

1 Answers 11 Views

When the bolt is very yielding as compared to the connected members, then the resultant load on the bolt will be equal to the?

1 Answers 4 Views

The bolt is subjected to __________ when the nut is tightened by putting the washer beneath it.?

1 Answers 5 Views

Nominal and effective interest rates are equal, when the interest is compounded?

1 Answers 5 Views

Effective and nominal interest rates are equal, when the interest is compounded?

1 Answers 5 Views

Height of liquid in agitation tank is normally maintained equal to the tank diameter. However, if the tank is too tall and a large liquid hold up is desired, then two or more impellers mounted on the same shaft may be used. The clearance between the tank bottom and the bottom most impeller should be about (where, D = impeller diameter)?

1 Answers 6 Views

The initial tension (in newtons) in a bolt used for making a fluid tight joint like steam engine cover joints, is calculated by the relation (where d = Nominal diameter of bolt in mm)?

1 Answers 6 Views

The allowable shear stress in the web of mild steel beams decreases with (where ‘h’ is height and t is thickness)?

1 Answers 5 Views

এক্সাম দিয়ে মেধা যাচাই করুন

Job Preparation (1125)

Admission (754)

এসএসসি (10)

এইচএসসি (5)