- 0x2100
- 0x2101
- 0x2102
- 0x2142
Answer: Option 3 If you save a configuration and reload the router and it comes up either in setup mode or as a blank configuration, chances are you have the...
1 Answers 1 viewsAnswer: Option 3 The command show ip protocols will actually show you the broadcast address for each interface - too bad it isn't a possible answer. Your best answer is...
1 Answers 1 viewsAnswer: Option 2 The command traceroute (trace for short), which can be issued from user mode or privileged mode, is used to find the path a packet takes through an...
1 Answers 3 viewsAnswer: Option 3 Before you start to configure the router, you should erase the NVRAM with the erase startup-config command and then reload the router using the reload command.
1 Answers 1 viewsAnswer: Option 3 Since the configuration looks correct, you probably didn't screw up the copy job. However, when you perform a copy from a network host to a router, the...
1 Answers 1 viewsAnswer: Option 2 At the moment of OSPF process startup, the highest IP address on any active interface will be the Router ID (RID) of the router. If you have...
1 Answers 5 viewsAnswer: Option 3 Clearly, a person committing a heinous crime like murder or rape should be so punished as to set an example for others not to attempt such acts...
1 Answers 1 viewsAnswer: Option 5 Clearly, mercy death will serve as a liberation to those to whom living is more difficult and painful. But then, it is an inhuman act and does...
1 Answers 1 viewsAnswer: Option 3 If you have a Cisco router on one side of a Frame Relay network and a non-Cisco router on the other side, you would need to use...
1 Answers 1 views