- Privileged mode
- Global mode
- Setup mode
- NVRAM loaded mode
1 Answers
Call
Talk Doctor Online in Bissoy App
You save the configuration on a router with the copy running-config startup-config command and reboot the router. The router, however, comes up with a blank configuration. What can the problem be?
Answer: Option 3 If you save a configuration and reload the router and it comes up either in setup mode or as a blank configuration, chances are you have the...
1 Answers 1 views
If you wanted to delete the configuration stored in NVRAM, what would you type?
Answer: Option 1 The command erase startup-config deletes the configuration stored in NVRAM.
1 Answers 3 views
You need to find the broadcast address used on a LAN on your router. What command will you type into the router from user mode to find the broadcast address?
Answer: Option 3 The command show ip protocols will actually show you the broadcast address for each interface - too bad it isn't a possible answer. Your best answer is...
1 Answers 1 views
What command do you type to save the configuration stored in RAM to NVRAM?
Answer: Option 4 To copy the running-config to NVRAM so that it will be used if the router is restarted, use the copy running-config startup-config command (copy run start for...
1 Answers 1 views
The corporate office sends you a new router to connect, but upon connecting the console cable, you see that there is already a configuration on the router. What should be done before a new configuration is entered in the router?
Answer: Option 3 Before you start to configure the router, you should erase the NVRAM with the erase startup-config command and then reload the router using the reload command.
1 Answers 1 views
If routers in a single area are configured with the same priority value, what value does a router use for the OSPF Router ID in the absence of a loopback interface?
Answer: Option 2 At the moment of OSPF process startup, the highest IP address on any active interface will be the Router ID (RID) of the router. If you have...
1 Answers 5 views
Which command is used to delete the directory and all its contents in one step?
Answer: Option 3 Let'
1 Answers 1 views
Which router command allows you to view the entire contents of all access lists?
Answer: Option 2 To see the contents of all access lists, use the show access-lists command.
1 Answers 1 views
Which command will delete the contents of NVRAM on a router?
Answer: Option 4 The erase startup-config command erases the contents of NVRAM and will put you in setup mode if the router is restarted.
1 Answers 1 views
You need to configure a router for a Frame Relay connection to a non-Cisco router. Which of the following commands will prepare the WAN interface of the router for this connection?
Answer: Option 3 If you have a Cisco router on one side of a Frame Relay network and a non-Cisco router on the other side, you would need to use...
1 Answers 1 views