- Router (config) #copy current to starting
- Router#copy starting to running
- Router (config) #copy running-config startup-config
- Router#copy run startup
Answer: Option 2 Let the capacity of the tank be 100 litres Initially: A type petrol = 100 litres After first operation: A type petrol = $$\frac{{100}}{2}$$ = 50 litres B type petrol =...
1 Answers 1 viewsAnswer: Option 3 If you save a configuration and reload the router and it comes up either in setup mode or as a blank configuration, chances are you have the...
1 Answers 1 viewsAnswer: Option 1 The command erase startup-config deletes the configuration stored in NVRAM.
1 Answers 3 viewsAnswer: Option 3 If you delete the startup-config and reload the router, the router will automatically enter setup mode. You can also type setup from privileged mode at any time.
1 Answers 2 viewsAnswer: Option 3 Before you start to configure the router, you should erase the NVRAM with the erase startup-config command and then reload the router using the reload command.
1 Answers 1 viewsAnswer: Option 3 Since the configuration looks correct, you probably didn't screw up the copy job. However, when you perform a copy from a network host to a router, the...
1 Answers 1 viewsAnswer: Option 1 Let'
1 Answers 1 viewsAnswer: Option 4 Let'
1 Answers 2 viewsAnswer: Option 4 The erase startup-config command erases the contents of NVRAM and will put you in setup mode if the router is restarted.
1 Answers 1 views