How do I stop my centrifuge from spinning if it is not stopping?

Your hand is on top of the ball at the time of release. To achieve proper rotation, your hand should be closer to the middle line or horizon of the...

Keep your balance while on the bike and place both feet on the ground when stopping.

Before the stop line. If needed, you can slowly pull up a little and then stop again when you have a good view of traffic in all directions.

You shouldn't be spinning out in the first place. Try letting off the gas, turning the wheel the right way, gently braking, or crashing safely into a wall. The guys...

The heater is used to keep samples at a certain temperature, often to make it easier to mix substances together.

It's impossible. Friction and gravity will inevitably slow the Newton's Cradle to a complete stop.

You can tell if it's spinning in the wrong direction if it's difficult to cut, there's lots of smoke, or fire. To fix, switch off and disconnect the saw, use...

It can take a while to finish burning, depending upon your settings, sometimes hours. If all else fails, try returning after checking your settings.

You have to push in a button on the bit holder before you try to loosen the bit. Otherwise, the bit's just going to twist freely when you try to...

If you lower the temperature to steaming, you might be able to use the wool afterwards. However, when re-filling the pot, use hot water to avoid temperature shifts. A rapid...