Bissoy.com
Doctors Medicines MCQs Q&A

What is the automatic frequency control voltage of the FM transmitter VCO?

What is the automatic frequency control voltage of the FM transmitter VCO? Correct Answer DC voltage

1) Automatic gain control (AGC) works in FM radio transmitter/receiver that maintains Automatic controlling of weak and strong signals which is received by the radio receiver.

2) The automatic frequency control voltage of the FM transmitter VCO is DC voltage.

2) AGC maintains a constant level of the output signal based on the received signal nature.

3) AGC adjusts the gain of RF and IF amplifiers according to need.

4) AGC can handle problems like overloading and fading in the receiver.

[ alt="F1 S.B 31.7.20 Pallavi D 3" src="//storage.googleapis.com/tb-img/production/20/07/F1_S.B_31.7.20_Pallavi_D%203.png" style="width: 598px; height: 293px;">

Related Questions

Determine the value of current flow in VCO, when the NE566 VCO external timing resistor RT =250Ω and the modulating input voltage Vc=3.25V.(Assume Vcc=+5v).
Which of the following is/are the advantages of using a control chart for inspection? (i) A control chart indicates whether the process is in control or out of control. (ii) A control chart determines process variability. (iii) A control chart ensures product quality. (iv) Scrap or percentage reduction can be reduced by taking the necessary actions in time against the warnings indicated by control charts. (v) Control charts build up the reputation of the organization through customer’s satisfaction. (vi) The control chart can detect the unusual variations taking place in a process.
Calculate the transmitter output frequency if the transmitter uses a crystal oscillator with a frequency of 14.9 MHz and a frequency multiplier chain with factors of 2, 3, and 3.
The ratio between transmitter chip clock rate and the difference between the transmitter chip clock and difference between transmitter and receiver chip clock rates is called ___________
In active power and frequency control, a. Frequency should remain constant b. A considerable drop in frequency could result in low magnetizing currents in induction motors and transformers. c. The frequency of a system is dependent on reactive power balance. d. Relatively closed control of frequency ensures constancy of the speed of induction motors. Which of the above statements are incorrect?
Consider the following statements relating to synchro’s: 1. The rotor of the control transformer is either disc shaped 2. The rotor of the transmitter is so constructed as to have a low magnetic reluctance 3. Transmitter and control transformer pair is used as an error detector Which of these statements are correct?
Voltage to frequency conversion factor for VCO is
In an AM system receiver. the mixer translates the carrier frequency fc to a fixed intermediate frequency of 450 kHz. Given a broadcast signal of frequency 900 kHz. What is the corresponding image frequency when a superhetrodyne receiver is employed with local oscillator frequency greater than the broadcast signal frequency?
In the following question below are given three statements followed by three conclusions. Taking the given statements to be true even if they seem to be at variance from commonly known facts, read all the conclusions and then decide which of the given conclusion logically follows the given statements. Statements: I. All Watch are Digital. II. All Digital are Camera. III. No Camera is an Automatic. Conclusions: I. All Watch are Camera. II. No Digital is an Automatic. III. No Watch is an Automatic.
Assertion: The process of testing the frequency response of amplifier and filter can be done by sweep frequency generator that automatically varies its frequency over a pre-determined range. Reason: The sweep frequency generator should have a ramp generator which applies a linear ramp voltage the input of a voltage tuned oscillator (VTO).