Bissoy.com
Doctors Medicines MCQs Q&A

In the circuit shown in the figure, the channel length modulation of all transistors is non-zero (λ ≠ 0). Also, all transistors operate in saturation and have negligible body effect. The ac small signal voltage gain (Vo/Vin) of the circuit is

In the circuit shown in the figure, the channel length modulation of all transistors is non-zero (λ ≠ 0). Also, all transistors operate in saturation and have negligible body effect. The ac small signal voltage gain (Vo/Vin) of the circuit is Correct Answer <span class="math-tex">\( - {g_{m1}}\left( {{r_{01}}||\left( {\frac{1}{{{g_{m2}}}}||{r_{02}}} \right)||{r_{03}}} \right)\)</span>

Concept:

Small signal equivalent model of NMOS & PMOS is as shown:

\)

Related Questions

Consider the following statements regarding modulation : 1. The communication systems, where a weak signal is transmitted by the use of a modulation is essential in carrier signal. 2. When the frequency of the high frequency signal is varied in accordance with the intensity of the low-frequency weak signal, the modulation is said to be frequency modulation. 3. The process of recovering original baseband signal from the modulated signal is called phase modulation. Which of the above statements are correct ? 
The following coding system shows the letter codes for numbers. Excluding the exceptions mentioned below, the digits in the question are to be transformed into letter codes as follows: Digit 0 1 2 3 4 5 6 7 8 9 Letter Code A B C D E F G H I J Exceptions: i. If a number begins with a nonzero even digit, that digit should be coded as N. ii. If a number begins with a nonzero odd digit, that digit should be coded as P. iii. If a number begins and also ends with non-zero even digits, those two digits at the extreme ends should be coded as Q. iv. If a number begins and also ends with nonzero odd digits, those two digits at the extreme ends should be coded as W. v. If a number's middle digit is a multiple of 2 that digit should be coded as Z. Barring these exceptions, the other digits should be codified as per the above-mentioned letter codes. Find the appropriate code for the following number-group 3214067
Consider the following types of modulation: 1. Amplitude modulation 2. Frequency modulation 3. Phase modulation 4. Pulse modulation Which of the above modulation are used for telecasting TV programs?
In a 3-input CMOS NAND gate, the substrate terminals of NMOS transistors are grounded (lowest potential available in the circuit) and the substrate terminals of PMOS transistors are connected to VDD (maximum positive potential available in the circuit). Which of the following transistors may suffer in this circuit from the body bias effect?
If g is the transconductance and r is the resistance due to channel length modulation – what is the total voltage gain if both M2 and M3 has channel length modulation?
If g is the transconductance and r is the resistance due to channel length modulation – what is the total voltage gain if both M1 and M3 has channel length modulation?
If g is the transconductance and r is the resistance due to channel length modulation – what is the total voltage gain if only M1 has channel length modulation?
If g is the transconductance, r is the resistance due to channel length modulation and if M2 has channel length modulation but M1 doesn’t, what is the voltage gain at node x?
Some small cubes of same height 7 cm but variable length and width are put inside a large cuboid of height 21 cm. Length and width of cuboid is 32 cm and 24 cm, respectively. Small cubes are put such that cubes at the bottom most layer is of similar base area; second layer contains all the cubes of similar base area and third layer have all the cubes of similar base area. Which of the following statement(s) given below is / are TRUE? A: If side of each small cubes at bottom most layer is 8 cm, then maximum number of small cubes that can be put at bottom most layer is 12. B: If maximum of 48 cubes can be put at second layer, then side of each cube at second layer is 6 cm. C: If side of each small cubes at third layer is 1.6 cm, then maximum number of small cubes that can be put at third layer is 300.
A power line is coupled capacitively through various parasitic capacitances to a shielded signal line as shown in the figure. The conductive shield is grounded solidly at one end. Assume that the length of the signal wire extending beyond the shield, and the shield resistance are negligible. The magnitude of the noise voltage coupled to the signal line is