Bissoy.com
Doctors Medicines MCQs Q&A

When measuring phase angle between two waves using a CRO, the time base generator is connected to

When measuring phase angle between two waves using a CRO, the time base generator is connected to Correct Answer neither X nor Y plates

  • CRO is used to measure frequency and phase angle between two waves by operating under x-y mode
  • In x-y mode, two different waves of which the phase angle being calculated are applied to X and Y plates of CRO
  • In the x-y mode of operation, the time base generator is connected to neither X plate nor Y plate
  • Time-base generator is connected to Y plate of CRO in y-t mode operation

Related Questions

A three-phase cylindrical rotor synchronous generator has a synchronous reactance Xs and a negligible armature resistance. The magnitude of per phase terminal voltage is VA and the magnitude of per phase induced emf is EA. Considering the following two statements, P and Q, P: For any three-phase balanced leading load connected across the terminals of this synchronous generator, VA is always more than EA Q: For any three-phase balanced lagging load connected across the terminals of this synchronous generator, VA is always less than EA Which of the following options is correct?
Transient stability of the generator is dependent on (a) generator reactance; lower reactance decreases peak power and increases initial rotor angle. (b) how heavily the generator is loaded. (c) generator inertia; higher the inertia, slower the rate of the change of angle. (d) generator output during fault Which of the above is incorrect?
In the following question, the 1st and the last part of the sentence/passage are numbered 1 and 6. The rest of the sentence/ passage is split into four parts and named P, Q, R and S. These four parts are not given in their proper order. Read the sentence/passage and find out which of the four combinations is correct. 1. Earthquakes are the shaking and moving of the ground when energy is released in waves.   P. These waves are similar to ocean waves, which move through water. Q. These waves are called seismic waves.  R. Seismic waves, however, move through the ground. S. Earthquakes can also be caused by other natural events, such as landslides and volcanoes.  6. Manmade earthquakes happen because of nuclear testing and mining explosions.
The network formed by resistors and capacitors for modifying the rate of change of gain and the phase shift is called a compensating network. Which of the following statements are not correct ? (A) The main purpose of a compensating network is to modify the performance of op-amp ciruit over the desired frequency range (B) There are two types of op-amps : internally compensated and externally compensated (C) 741 C is an externally compensated op-amp while 709 C is internally compensated op-amp (D) The phase lag and phase lead are most commonly used compensating networks in op-amps (E) Phase lag contributes a positive phase angle and phase lead a negative phase angle Choose the most appropriate answer from the options given below : 
Which of the following statements is/are correct with respect to a Scott-connected transformer? I. It can do 3-phase to 2-phase conversion II. It can do 2-phase to 3-phase conversion III. It can do 2-phase to 4-phase conversion IV. It can do 3-phase to 4-phase conversion
When a 1-phase transformer is connected in parallel, there are four conditions for proper parallel operation, but when two or 3-phase transformer paralleling is done, there are two additional points along with those four conditions applied for 1-phase. Statement 1 - The phase sequence must be the same. Statement 2 - The phase shift between primary and secondary voltages must be the same for all transformers connected in parallel. From the above two Statements (s), which is/are the correct conditions in this regard?
দুটি সুসঙ্গত উৎস থেকে λ দৈর্ঘ্যের দুটি তরঙ্গ সমদশায় বের হয় । একটি বিন্দুতে যেখানে তরঙ্গ দুটি মিলিত হয় সেখানে তাদের দশা পার্থক্য 90° । তরঙ্গ দুটির অতিক্রান্ত পথ পার্থক্য তখন কত ? ( Two coherent sources emit waves of wavelength λ which are in phase. which are in phase. The two waves meet at a point where they have a phase difference of 90°. Which of the following could be the traversed path difference between the waves?)
Necessary condition for obtaining an interference pattern when light waves (of same frequency) from two points S1 and S2 superpose is:   Intensity of two waves Phase difference between the two waves at S1 and S2 must be 1) Must be equal Zero 2) Must be equal π  3) Must be equal Constant with time but not necessarily zero 4) Need not be equal Constant with time but not necessarily zero
Which of the following statements is correct regarding secondary seismic waves (S waves)? I. They are also called longitudinal waves. II. These waves cannot pass through liquid materials. III. Their speed is lower than surface waves.
Which of the following statements are not true for sound ? (a) Sound waves are transverse waves. (b) Audible sound waves have frequency range of 20 kHz and above. (c) Sound waves require medium for propagation. (d) Non-periodic sound waves are termed as ‘Noise’.