Bissoy.com
Doctors Medicines MCQs Q&A

When a flip-flop is reset its output will be

When a flip-flop is reset its output will be Correct Answer Q = 0, Q̅ = 1

Flip Flop:

  • Flip-flops are the basic elements for storing information. They are made of logic gates.
  • Flip-flops are the Sequential circuit. 
  • Flip-flops can store a 1-bit of information.
  • For flip-flop, its input can affect the output only when the enable signal changes (falling edge or rising edge).
  • ​When a flip-flop is reset its output will be ​Q = 0, Q̅ = 1

[ alt="26 June 1" src="//storage.googleapis.com/tb-img/production/19/08/26%20June_1.png" style="width: 160px; height: 46px;">

The difference between latches and flip flops is shown

Latches

Flip Flops

Latches are building block of sequential circuits and they are built using logic gates

Flip flops are also building blocks of sequential circuits but they are made using latches

Latches continuously change the input and output changes correspondingly

Flip flop output changes only when the clock is applied

Latches are level sensitive

Flip flops are edge sensitive

Related Questions

Consider the following statements: 1. Race-around condition occurs in a JK flipflop when the inputs are 1, 1 2. A flip-flop is used to store one bit of information 3. A transparent latch consists of D-type flipflops 4. Master-slave configuration is used in a flipflop to store two bits of information Which of the above statements are correct?
Consider the following statements regarding RESET instruction of 8085 microprocessor 1. PC contents become 0000H. 2. All interrupts are enabled. 3. RESET OUT pin is at logic 0. Which of the above statements is/are correct?
In synchronous reset, reset is sampled with respect to _______
In asynchronous reset, reset is sampled independently of the _______
Synchronous reset is a fast reset.
What signal should be sent to the RESET pin of the Adafruit FONA 3G+GPS Breakout in order to perform a Hard Reset of the module?
Wages of the workers are normally, the proportionality derived from their efficiency. But the concept of efficiency of labour is itself vague such as amount of physical output, output per man hour or output per man shift. But output is not the function of man alone. There are other factors which affect the output. Which among the following is/are not the factor(s) that would affect the output directly?
1. Physical condition of work
2. Nature of machinery
3. Technical process
4. Quality of raw material
5. System of management
6. Role of fellow workers
7. Competitors in the market
The pin that clears the command, request and temporary registers, and internal first/last flipflop when it is set is
Realization of JK flipflop is based on
A system provides output yi(t) when xi(t) is applied. If the system is said to be LTI then which of the following properties must satisfy? (i).If the input is x3 = ax1(t) + bx2(t), then output must be y3(t) = ay1(t) + by2(t) (ii).If the input is x(t – T), then the output must be y (t – T) (iii).If the input is x3 = ax1(t) + bx2(t), then output must be y3(t) = ay1(t) * by2(t) (iv).If the input is x(t – T), then the output must be y(t + T)