Bissoy.com
Doctors Medicines MCQs Q&A

The usual value of helix angle of a drill is:

The usual value of helix angle of a drill is: Correct Answer 30°

Helix angle is the angle between the leading edge of the land and the axis of the drill. It is also known as the spiral angle. The usual value of helix angle of a drill is 30°.

[ alt="5aa6717fbf30f21d3c7da5cf" src="//storage.googleapis.com/tb-img/production/18/03/5aa6717fbf30f21d3c7da5cf.PNG" style="height:190px; width:85px">

Related Questions

If Rati travels at his usual speed for ‘x’ hours, he covers the same distance as he covered when he travels at a speed 30 km/hr less than usual, but for (x + 3) hours. Which of the following can be determined? (A) If he travels at 20 km/hr less speed than usual, he can cover a distance of 240 km in (x - 1) hours. What is the value of ‘x’? (B) If travels at his usual speed for (t + 2) hours, and at 50% of his usual speed for (t - 2) hours, his average speed for the journey is 68 km/hr. What is his usual speed? (C) His usual speed (in km/hr) is a multiple of 5 between 40 and 50 (both inclusive). If ‘x’ is a whole number, what is his usual speed? (D) If he travels at his usual speed for ‘t’ hours, he covers a distance of 400 km. What is the value of ‘x’?
Arjun covers a certain distance from his home to college at a usual speed of 24 km/hr and takes a certain time. When he increases usual speed by 6 km/hr, he takes 30 minutes less than usual. If he reduces his usual speed by 4 km/hr, he takes 30 minutes more than usual. Find the distance from his home to college. 
Mr A started half an hour later than usual for the marketplace. But by increasing his speed to $$\frac{3}{2}$$ times his usual speed he reached 10 minutes earlier than usual. What is his usual time for this journey?
Which of the following are percussion drills? (i) Shot drill (ii) Diamond drill (iii) Wagon drill (iv) Churn drill
Which of the following are percussion drills?
(i) Shot drill
(ii) Diamond drill
(iii) Wagon drill
(iv) Churn drill
The base diameter of a conical helix is 100 mm. The angle between the base and slanting side is 45 degrees. Pitch of helix is 5 mm. What is the height of helix and number of revolutions?
The base diameter of a conical helix is 80 mm. The angle between the base and slanting side is 60 degrees. Pitch of helix is 6 mm. What is the height of helix and number of revolutions?
Base diameter of conical helix is 50 mm, height of helix is 30 mm, angle between the base and slanting side of cone is 60 degrees. What is the top end diameter of the helix?
The usual value of the helix angle of a drill is
If the helix angle of the drill is made ________ 30°, then the torque required to drive the drill at a given feed will be more.