Bissoy.com
Doctors Medicines MCQs Q&A

Related Questions

Consider the following statements regarding V-belt drive : 1. The groove angle of the sleeve is less than the belt section angle 2. The efficiency of a V-belt drive is higher than that of a flat belt drive 3. The groove angle is so made that the belt gets wedged in the groove  Which of the above statements are correct ? 
Which one of the following four addresses is NOT EXACTLY same as the one given below? Cabramatta 360 Elizabeth Drive, 2170 Mount Pritchard, Australia (i) Cabramatta 360 Elizabeth Drive, 2170 Mount Pritchard, Australia (ii) Cabramatta 360 Elizabeth Drive, 2170 Mount Pritchard, Australia (iii) Cabrematta 360 Elizabeth Drive, 2170 Mount Pritchard, Australia (iv) Cabramatta 360 Elizabeth Drive, 2170 Mount Pritchard, Australia
Which one of the following four addresses is NOT EXACTLY same as the one given below?  Kedrick Shaw 72 Glenwood Drive, Thornton, NSW 2322, Australia (i)  Kedrick Shaw  72 Glenwood Drive,  Thornton, NSW 2322, Australia (ii) Kedrick Shaw  72 Glenwood Drive,  Thornton, NSW 2322, Australia (iii) Kedrick Shaw  72 Glenwood Drive,  Thornton, NSW 2322, Australia (iv) Kedrick Shaw  72 Glemwood Drive,  Thornton, NSW 2322, Australia
A fluted feed seed drill has eight furrow openers of single disc type. The furrow openers are spaced 25 cm apart and the main drive wheel has a diameter of 120 cm. How many turns of main drive wheel would occur when the seed drill has covered one hectare of area?
The base diameter of a conical helix is 100 mm. The angle between the base and slanting side is 45 degrees. Pitch of helix is 5 mm. What is the height of helix and number of revolutions?
The base diameter of a conical helix is 80 mm. The angle between the base and slanting side is 60 degrees. Pitch of helix is 6 mm. What is the height of helix and number of revolutions?
Base diameter of conical helix is 50 mm, height of helix is 30 mm, angle between the base and slanting side of cone is 60 degrees. What is the top end diameter of the helix?
Angle ‘A’ of a cyclic quadrilateral ABCD is 53° less then angle B. Angle B is twice of angle C and angle C is 40° more than angle D. What would be the measure of angle A?
When the value of helix angle increases in drills, the value of required torque for rotation of drill will
If l=length of travel of the drill in mm, n=rpm of the drill, s= feed per revolution of the drill in mm. Then machining time can be given as_____