Bissoy.com
Doctors Medicines MCQs Q&A

The process of applying DC voltages across different terminals of a transistor is called

The process of applying DC voltages across different terminals of a transistor is called Correct Answer Biasing

  • Biasing is the process of establishing Quiescent voltage (VCE) and Quiescent current to obtain faithful amplification of the AC signal
  • This is achieved by setting dc voltage and current in the middle of the load line by applying dc voltages
  • DC loading line is shown below

[ alt="667" src="//storage.googleapis.com/tb-img/production/18/02/667.PNG" style="height: 137px; width: 204px;">

Related Questions

For the circuit given below, the inductance measured across the terminals 1 and 2 was 15 H with open terminals 3 and 4. It was 30 H when terminals 3 and 4 were short-circuited. Both the inductors are having inductances 2H. The coefficient of coupling is ______________
A three-phase cylindrical rotor synchronous generator has a synchronous reactance Xs and a negligible armature resistance. The magnitude of per phase terminal voltage is VA and the magnitude of per phase induced emf is EA. Considering the following two statements, P and Q, P: For any three-phase balanced leading load connected across the terminals of this synchronous generator, VA is always more than EA Q: For any three-phase balanced lagging load connected across the terminals of this synchronous generator, VA is always less than EA Which of the following options is correct?
In an ideal op amp the open-loop gain is 103. The op amp is used in a feedback circuit, and the voltages appearing at two of its three signal terminals are measured as v2 = 0V and v3 = 2V where it is assumed that v1 and v2 are input terminals and v3 is the output terminal. The value of the differential (vd) and common-mode (vcm)signal is
Consider the following statements: SCR can be turned on by 1. Applying anode voltage at a sufficiently fast rate 2. Applying sufficiently large anode voltage 3. decreasing the temperature of SCR 4. Applying sufficiently large gate current Which of the above statements are correct?
For an ideal operational amplifier (except for the fact that it has finite gain) one set of the value for the input voltages (v2 is the positive terminal v1 is the negative terminal) and output voltage (v0) as determined experimentally is v1= 2.01V, v2=2.00V and v0= -0.99V. Experiment was carried with different values of input and output voltages. Which of the following is not possible considering experimental error?
A voltage source VAB = 4 sin wt is applied to the terminals A and B of the circuit shown in the given figure. The diodes are assumed to be ideal. The impedance by the circuit across the terminals A and B is
Under normal operating conditions, the gate terminals of an n-channel Junction Field Effect Transistor UFET) and an n-channel Metal Oxide Semiconductor Field Effect Transistor (MOSFET) are
Which of the following can be true for selecting base learners for an ensemble?
1. Different learners can come from same algorithm with different hyper parameters
2. Different learners can come from different algorithms
3. Different learners can come from different training spaces
By selling a transistor for Rs. 572, a shopkeeper earns a profit equivalent to 30% of the cost price of the transistor. What is the cost price of the transistor?
In which of the below-mentioned logic families, the transistors operate between cut-off and active (non-saturation) states? (i) Transistor-Transistor Logic (TTL) (ii) Schottky TTL (iii) Diode Transistor Logic (DTL) (iv) Emitter Coupled Logic (ECL) Choose the correct answer from the code given below: Code: