Bissoy.com
Doctors Medicines MCQs Q&A

The initial value of DC offset in a three-phase fault depends on:

The initial value of DC offset in a three-phase fault depends on: Correct Answer Instantaneous source voltage at the instance of fault

  • AC circuit transient current is composed of symmetrical short circuit current (AC fault current) and DC offset.
  • The value of DC offset (magnitude of the initial value of DC offset) can be between zero to the maximum value of AC fault current depending upon different values of (voltage phase angle)
  • As the value of α is decided by the instantaneous source voltage at the instant of short circuit the value of DC offset is decided by the instantaneous source voltage at the instant of short circuit.

Related Questions

P, Q and R invested in a business for 2.5 years, such that P’s initial investment was 60% more than Q’s initial investment, while R’s initial investment was 25% less than P’s initial investment. After 10 months, each of them invested 25% of their initial investment. What part of the total profit will P received after 2.5 years?
The following question has three statements. Study the question and the statements to decide which of the statement(s) is/are necessary to answer the question. A train starts from point A towards point B, but after ‘n’ hours, its speed becomes 2/3rd of the normal speed due to some fault. Find the value of n. Statement I: The fault occurred at a distance of 800 km from the destination Statement II: Had the fault occurred 200 km further, the train would have got late by 30 min Statement III: The train got late by 40 min
Calculate the value of the fault impedance if the fault voltage is 2 V and fault current is 4 A.
A sustained three phase fault occurs in the power system shown in the figure. The current and voltage phasors during the fault (on a common reference), after the natural transients have died down, are also shown. Where is the fault located?  
Three – phase to ground fault takes place at locations F1 and F2 in the system shown in the figure If the fault takes place at location F1, then the voltage and the current at bus A are VF1 and IF1 respectively. If the fault takes place at location F2, then the voltage and the current at bus A are VF2 and IF2 respectively. The correct statement about voltages and currents during faults at F1 and F2 is
The fault not belonging to the classification of fault with the attitude of fault as basis ___________
The fault where fault strike is parallel to the dip of the layers broken and disrupted by the fault?
The fault which is the result of both fault scarps and fault-line scarps is?
The higher the width of the stacking fault _________ will be the stacking-fault energy. Higher the stacking fault energy __________ will be the cross slip.
Generally, tortuous liability has an element of fault to support it. In which one of the following Acts, recently a provision has been made in India, which provides for meeting claims arising both on the basis of fault principle and no fault principle?