Related Questions

Two outlets of a motor manufacturing company reported that revenue from outlet x in 2013 was down 11 percent from 2012. and revenue from outlet Y in 2013 were up 7 percent from 2012. If total revenue from outlet X & Y in 2013 was up 1 percent from 2012, what is the ratio of revenue from outlet X in 2012 revenue from outlet Y in 2012?
A 1 : 2
B 4: 5
C 1 : 1
D 3: 2
Due to the recession, a show room reported that revenue from luxury car sales were down by 11% and revenue from economy car sales were up by 7% . If the total revenue were up by 1% then what is the ratio of revenue from luxury car sales to revenue from economy car sales ?
A 3 :2
B 11:7
C 4:5
D 1:2
The permanent settlement was made in Bengal in the sphere of revenue administration by
A William Pitt
B Hastings
C William Bentic
D Lord Cornwallis
A company generated revenue of Tk. 125,000 in 2012 which was 12.5% of its gross revenue. In 2013, the gross revenue increased by Tk. 250,000. What is the percentage increase in the revenue in 2013?
A 12.5%
B 20%
C 25%
D 50%
A company generated revenue of Tk 125,000 in 2012 which was 12.5% o its gross revenue. In 2013, the gross revenue increased by Tk. 250,000. What is the percentage increase in the revenue in 2013?
A 12.5%
B 20%
C 25%
D 50%
When was the permanent settlement introduced in Bengal?
A 1792
B 1972
C 1793
D 1857
Who among the following introduced the Permanent Settlement of Bengal in 1793?
A Lord Cornwallis
B Robert Clive
C John Adam
D Lord Ripon
The Permanent settlement introduced by Cornwallis is in Bengal is known as
A Roytwari System
B Mahalwari System
C Zamindari System
D Iqtadari System
Who introduced the permanent settlement in Bengal?
A Lord Cornwallis
B Lord Dalhousie
C William Bentinck
D Lord Curzon
In testing a pile by load test, pile platform is loaded with one and half times the design load and a maximum settlement is noted. The load is gradually removed and the consequent rebound is measured. For a safe pile, the net settlement (i.e. total settlement minus rebound) per tonne of test load should not exceed
A 10 mm
B 15 mm
C 20 mm
D 25 mm

Next steps