Related Questions

The cost of picture frame M is Tk. 10.00 less than 3 times the cost of picture frame N. If the cost of frame M is Tk. 50.00, what is the cost of frame N?
A Tk. 13.33
B Tk. 16.66
C Tk. 20.00
D Tk. 26.66
The cost of picture frame M is TK. 10.00 less than 3 times the cost of picture frame N. If the cost of frame M is TK. 50.00 , what is the cost of frame N?
A TK. 13.33
B TK. 16.66
C TK. 20.00
D TK. 26.66
A circular frame with a width of 2 inches surrounds a circular photo with a diameter of 8/ inches Assuring that the area of the frame does not overlap the area of the photo what is the area of the frame?
A 8 pie
B 20pie
C 25pie
D 11 pie
When the _____________ method is passed an animated image as its image argument, the user agent must use the poster frame of the animation, or, if there is no poster frame, the first frame of the animation.
A measureText()
B imageData()
C drawImage()
D setImage()
Admittance relay is _______ relay.
A impedance
B directional
C non-directional
D none of the above
An overnight express firm charges Tk. 2 per kg for the first 10 kg of packet weight and Tk. 1 for each kg of or fraction of kg over 10 kg of packet weight. How much will it charge to ship a package which weighs 17.5 kg?
A 8
B 20
C 28
D 36
When a router is connected to a Frame Relay WAN link using a serial DTE interface, how is the clock rate determined?
A Supplied by the CSU\/DSU
B By the far end router
C By the clock rate command
D By the Physical layer bits stream timing
Change into negative: 'He is the only person fit for the job.' The best answer is:- fit for the job.
A He is not the only one
B No other person but he is
C No other person but you are
D He is none but
You need to configure a router for a Frame Relay connection to a non-Cisco router. Which of the following commands will prepare the WAN interface of the router for this connection?
A Router (config-if) #encapsulation frame-relay q933a
B Router (config - if) #encapsulation frame-relay ansi
C Router (config - if) #encapsulation frame-relay ietf
D Router (config - if) #encapsulation frame-relay cisco
When setting up Frame Relay for point-to-point subinterfaces, which of the following must not be configured?
A The Frame Relay encapsulation on the physical interface
B The local DLCI on each subinterface
C An IP address on the physical interface
D The subinterface type as point-to-point
E PAP

Next steps