Bissoy.com
Doctors Medicines MCQs Q&A

When setting up Frame Relay for point-to-point subinterfaces, which of the following must not be configured?

When setting up Frame Relay for point-to-point subinterfaces, which of the following must not be configured? Correct Answer An IP address on the physical interface

It is very important to remember when studying the CCNA exam objectives, and when configuring Frame Relay with point-to-point subinterfaces, that you do not put an IP address on the physical interface.

Related Questions

Consider the following statements with respect to a relay: 1. A relay is energized if NC contacts are opened. 2. The pickup current is the minimum relay coil current required to keep a relay energized. Which of the above statements is/are correct?
If a transformer is provided with differentially connected relay. To prevent the mal operation of the relay, the relay relay operating coil is biased with ______
Consider the following statements regarding 'setting of cement': 1. Low-heat cement sets faster than OPC. 2. Final setting time decides the strength of cement. 3. Initial setting time of Portland PozzoIlona is 30 minutes. 4. Air-induced setting is observed when stored under damp conditions. 5. Addition of gypsum retards the setting time. Which of the above statements are correct?
Your network is configured as shown in the exhibit. "Engineering! and Salesl have DHCP installed up them." All the servers are Windows 2000 Server computers that use TCP/IP as the only network protocol. The sales department uses one subnet and has servers named Salesl and Sales2. The engineering department uses another subnet and has servers named Engineeringl and Engineering2. Salesl and Engineeringl are configured to act as DHCP servers. The router that joins the two subnets is not RFC 1542 compliant and does not support DHCP/BOOTP relay. You want to allow Salesl and Engineeringl to support client computers on each other's subnets. What should you do?
There exist three terminals in a relay called C, NO, NC, in an application, it is desired that whenever the relay is active the load must be connected be supply, otherwise the load will be disconnected from supply. Which of the following connection type in relay will provide solution to the stated problem?
To configure the VLAN trunking protocol to communicate VLAN information between two switches, what two requirements must be met?
1. Each end of the trunk link must be set to the IEEE 802.1e encapsulation.
2. The VTP management domain name of both switches must be set the same.
3. All ports on both the switches must be set as access ports.
4. One of the two switches must be configured as a VTP server.
5. A rollover cable is required to connect the two switches together.
6. A router must be used to forward VTP traffic between VLANs.
Buchholz relay is a protection relay used in oil immersed transformers. Under what conditions does Buchholz Relay will NOT operate?
A solenoid type relay is what type of relay as far as the relay timing is concerned?
If a transformer is provided with differentially connected relay. To prevent the mal operation of the relay, the relay restraining coil is biased with ______________
Consider the following statements: 1. When the number of members (n) and joints (j) are such that the equation n = (2j — 3) is satisfied, the framed structure is said to be a perfect structure. 2. In a redundant frame, the number of members is less than that required for a perfect frame. 3. If, in a framed structure, the number of members provided is more than that required for a perfect frame, it is called as a deficient frame. Which of the above statements is/are correct ? (a) (b) (c) (d)