Related Questions

Lower BWG means __________ of the tube.
A Lower thickness
B Lower cross-section
C Outer diameter
D Inner diameter
Minimum tube pitch recommended for shell and tube heat exchangers is about __________ times the outside diameter of the tube.
A 1.25
B 1.75
C 2.5
D 3.5
In a shell and tube heat exchanger having square pitch, the shell side equivalent diameter is given by (where, P = pitch, d = outside diameter of the tube)
A $$\frac{{4\left( {{{\text{p}}^2} - \pi {{\text{d}}^2}/4} \right)}}{{\pi {\text{d}}}}$$
B $$\frac{{{{\text{p}}^2} - \pi {{\text{d}}^2}/4}}{{\pi {\text{d}}}}$$
C $$\frac{{4{{\text{p}}^2}}}{{\pi {\text{d}}}}$$
D $$\frac{{\pi {\text{d}}}}{{4{{\text{p}}^2}}}$$
If 'blue' means 'green', green' means 'yellow' 'yellow' means 'orange', 'orange' means 'black', 'black' means 'white', 'white' means 'red', 'red' means 'pink', 'pink' means 'brown', 'brown' means 'grey', than what is the color of human blood?
A black
B red
C white
D orange
In most of the shell and tube heat exchangers, the tube pitch is generally __________ the tube diameter.
A Less than
B 1.25-1.50 times
C 2.5 times
D One-fourth of
For the same diameter and thickness of tube, a water tube boiler has ________ heating surface as compared to fire tube boiler.
A More
B Less
C Equal
D None of these
For the same diameter and thickness of tube, a water tube boiler compared to a fire tube boiler has
A More heating surface
B Less heating surface
C Equal heating surface
D Heating surface depends on other parameters
Capillary rise of mercury in a small diameter tube is proportional to (where, d = diameter of the tube, σ = surface tension of mercury)
A d
B $$\frac{1}{{\text{d}}}$$
C $$\sigma $$
D $$\frac{l}{\sigma }$$
In which of the following evaporators, steam is fed inside the tube while the liquor is outside the tube?
A Long tube vertical evaporator
B Short tube vertical evaporator
C Horizontal tube evaporator
D None of these
In a shell and tube heat exchanger for a given heat transfer surface area, smaller diameter tubes are favoured as compared to larger diameter ones ; because the smaller diameter tubes
A Are easier to clean
B Are less prone to fouling
C Can be fitted into a smaller shell diameter hence the cost of the heat exchanger would be less
D None of these

Next steps