Related Questions

Distribution transformers are generally designed for maximum efficiency around
Power transformers should be designed to have maximum efficiency
Power transformers are designed to have maximum efficiency at
Two transformers are connected in parallel. These transformers do not have equal percentage impedance. This is likely to result in
If Bashar can run around a ground four times in 20 minutes and Rahim can run around the same ground three times in 12 minutes, who can run around that ground more times in an hour, and how many times more can he run around ?
Each of the following problem has a question and two statements which are labeled 1. and. Use the data given in 1. and 2. to decide whether the statements are sufficient to answer the question.Select one of the following . a.Statements (1) ALONE is sufficient,but (2) ALONE is not sufficient. b.Statements (2) ALONE is sufficient,but (1) ALONE is not sufficient. c. Both statement TOGETHER are sufficient but statement alone is sufficient . A fly crawls around the outside of a circle once.A second fly crawls around the outside of a square once.Which fly travels further ? (1) The diagonal of the square is equal to the diagonal of the circle.(2) The fly crawling around the circle took more time to complete has journey than the fly cawing around the square.
D.C. generators are normally designed for maximum efficiency around
A single phase transformer has a maximum efficiency of 90% at full load and unity power factor. Efficiency at half load at the same power factor is -
Two circular dials of exactly the same size are mounted on a wall side by side in such a way that their perimeters touch at one point. Dial 1, which is on the left , spins clockwise around its center , and dial 2 , which is on the right spins counter clockwise around its center . (Assume that there is no friction at the point of contact between the dials.) Each dial is marked on its perimeter at three points that are at equale distances around the points arked ondial 1 are N, O, and P and the points marked on dial 2 are X, Y, and Z. If points O and Z are just meeting at the point of contact between the dials , and if dial 1 spins at the same speed as dial 2, what is the smallest number of revolutions of each dial that will bring O and Z together again?
Natural air cooling is generally restricted for transformers up to