Related Questions

Power transformers are generally designed to have maximum efficiency around
A no-load
B half-load
C near full-load
D 10% overload
Power transformers should be designed to have maximum efficiency
A at one-fourth load
B at one-half load
C at or near full load
D any of the above
Power transformers are designed to have maximum efficiency at
A nearly full load
B 70% full load
C 50% full load
D no load
If Bashar can run around a ground four times in 20 minutes and Rahim can run around the same ground three times in 12 minutes, who can run around that ground more times in an hour, and how many times more can he run around ?
A Bashar, three times more
B Rahim , three times more
C They both go around 12 times
D Bashar, eight times more
Each of the following problem has a question and two statements which are labeled 1. and. Use the data given in 1. and 2. to decide whether the statements are sufficient to answer the question.Select one of the following . a.Statements (1) ALONE is sufficient,but (2) ALONE is not sufficient. b.Statements (2) ALONE is sufficient,but (1) ALONE is not sufficient. c. Both statement TOGETHER are sufficient but statement alone is sufficient . A fly crawls around the outside of a circle once.A second fly crawls around the outside of a square once.Which fly travels further ? (1) The diagonal of the square is equal to the diagonal of the circle.(2) The fly crawling around the circle took more time to complete has journey than the fly cawing around the square.
A A
B B
C C
D D
Two transformers are connected in parallel. These transformers do not have equal percentage impedance. This is likely to result in
A short-circuiting of the secondaries
B power factor of one of the transformers is leading while that of the other lagging
C transformers having higher copper losses will have negligible core losses
D loading of the transformers not in proportion to their kVA ratings
D.C. generators are normally designed for maximum efficiency around
A Full load
B Rated r.p.m.
C Rated voltage
D All of the above
The usual values of maximum flux densities for distribution transformers using hot rolled silicon steel are
A 0.5 to 0.8 Wb/m2
B 0.8 to 1.0 Wb/m2
C 1.1 to 1.35 Wb/m2
D 1.4 to 1.8 Wb/m2
Which of the following protection is normally not provided on small distribution transformers?
A Overfluxing protection
B Buchholz relay
C Overcurrent protection
D All of the above
Two circular dials of exactly the same size are mounted on a wall side by side in such a way that their perimeters touch at one point. Dial 1, which is on the left , spins clockwise around its center , and dial 2 , which is on the right spins counter clockwise around its center . (Assume that there is no friction at the point of contact between the dials.) Each dial is marked on its perimeter at three points that are at equale distances around the points arked ondial 1 are N, O, and P and the points marked on dial 2 are X, Y, and Z. If points O and Z are just meeting at the point of contact between the dials , and if dial 1 spins at the same speed as dial 2, what is the smallest number of revolutions of each dial that will bring O and Z together again?
A 1
B 2
C 3
D 4

Next steps