Related Questions

Generators for peak load plants are usually designed for maximum efficiency at
A 25 to 50 percent full load
B 50 to 75 percent full load
C full load
D 25 percent overload
Two generators are running in parallel. One of the generators may run as motor for which of the following reasons?
A The direction of that generator is reversed
B The speed of that generator is increased
C The field of that generator is weakened
D That generator takes large share of loads
If Bashar can run around a ground four times in 20 minutes and Rahim can run around the same ground three times in 12 minutes, who can run around that ground more times in an hour, and how many times more can he run around ?
A Bashar, three times more
B Rahim , three times more
C They both go around 12 times
D Bashar, eight times more
Each of the following problem has a question and two statements which are labeled 1. and. Use the data given in 1. and 2. to decide whether the statements are sufficient to answer the question.Select one of the following . a.Statements (1) ALONE is sufficient,but (2) ALONE is not sufficient. b.Statements (2) ALONE is sufficient,but (1) ALONE is not sufficient. c. Both statement TOGETHER are sufficient but statement alone is sufficient . A fly crawls around the outside of a circle once.A second fly crawls around the outside of a square once.Which fly travels further ? (1) The diagonal of the square is equal to the diagonal of the circle.(2) The fly crawling around the circle took more time to complete has journey than the fly cawing around the square.
A A
B B
C C
D D
Distribution transformers are generally designed for maximum efficiency around
A 90% load
B Zero load
C 25% load
D 50% load
Power transformers are generally designed to have maximum efficiency around
A no-load
B half-load
C near full-load
D 10% overload
Two circular dials of exactly the same size are mounted on a wall side by side in such a way that their perimeters touch at one point. Dial 1, which is on the left , spins clockwise around its center , and dial 2 , which is on the right spins counter clockwise around its center . (Assume that there is no friction at the point of contact between the dials.) Each dial is marked on its perimeter at three points that are at equale distances around the points arked ondial 1 are N, O, and P and the points marked on dial 2 are X, Y, and Z. If points O and Z are just meeting at the point of contact between the dials , and if dial 1 spins at the same speed as dial 2, what is the smallest number of revolutions of each dial that will bring O and Z together again?
A 1
B 2
C 3
D 4
The artificial draught normally is designed to produce
A less smoke
B more draught
C less chimney gas temperature
D all of the above
Sewage treatment units are normally designed for
A 5 - 10 years
B 15 - 20 years
C 30 - 40 years
D 40 - 50 years
Commercial packed scrubbers are normally designed for a pressure drop range of __________ mm water coloumn per metre of packed height.
A 4-8
B 17-34
C 52-68
D 88-105

Next steps