Bissoy.com
Doctors Medicines MCQs Q&A

Related Questions

Consider the following statements for deflection and null type instruments: 1. Deflection type of instruments are more accurate than null type of instruments. 2. Deflection type of instruments can be highly sensitive as compared with the null type of instruments. 3. Null type of instruments are more suitable for measurements under dynamic conditions than deflection type of instruments. Which of the above statements are not correct?
Consider the following statements in connection with deflection-type and null-type instruments: 1. Null-type instruments are more accurate than the deflection-type ones. 2. Null-type of instrument can be highly sensitive compared to a deflection-type instrument. 3. Under dynamic conditions, null-type instruments are less preferred to deflection-type instruments. 4. Response is faster in null-type instruments as compared to deflection-type instruments. Which of the above statements are correct?
Which of the following statements is/are correct with respect to a Scott-connected transformer? I. It can do 3-phase to 2-phase conversion II. It can do 2-phase to 3-phase conversion III. It can do 2-phase to 4-phase conversion IV. It can do 3-phase to 4-phase conversion
Which of the following statements are true? a. As load increases armature current decreases, regardless of excitation. b. For under and over excited motors, power factor tends to approach zero with increase in load c. With normal excitation when load is increased, change in armature current is greater than in power factor which tends to become increasingly leading. d. Both with under and over excitation, change in power factor is greater than in armature current with increase in load.
Consider the following statement: 1. Initial load tests and routine load tests are carried out on test piles and working Piles, respectively. 2. In a pile load test, the allowable load can be taken equal to half the ultimate load at which the total settlement amounts to one-tenth of the pile diameter. 3. In a pile load test, the allowable load can be taken equal to two-thirds of the total toad which causes a plastic settlement of 6 mm. Which of the above statements are correct?
A single phase transformer has a maximum efficiency of 90% at full load and unity power factor. Efficiency at half load at the same power factor is -
A three-phase cylindrical rotor synchronous generator has a synchronous reactance Xs and a negligible armature resistance. The magnitude of per phase terminal voltage is VA and the magnitude of per phase induced emf is EA. Considering the following two statements, P and Q, P: For any three-phase balanced leading load connected across the terminals of this synchronous generator, VA is always more than EA Q: For any three-phase balanced lagging load connected across the terminals of this synchronous generator, VA is always less than EA Which of the following options is correct?
The network formed by resistors and capacitors for modifying the rate of change of gain and the phase shift is called a compensating network. Which of the following statements are not correct ? (A) The main purpose of a compensating network is to modify the performance of op-amp ciruit over the desired frequency range (B) There are two types of op-amps : internally compensated and externally compensated (C) 741 C is an externally compensated op-amp while 709 C is internally compensated op-amp (D) The phase lag and phase lead are most commonly used compensating networks in op-amps (E) Phase lag contributes a positive phase angle and phase lead a negative phase angle Choose the most appropriate answer from the options given below : 
Which of the following is not correctly matched? 1. Percussion Instruments: instruments are struck to produce sound. 2. Wind Instruments: need air to flow through them to produce sound. 3. String Instruments: use one or many tightly tied strings that when struck vibrate to create a sound.
Two statements are given, followed by three conclusions numbered I, II and III. Assuming the statements to be true, even if they seem to be at variance with commonly known facts, decide which of the conclusions logically follows(s) from the statements. Statements: All computers are instruments. Some machines are computers. Conclusion: I All instruments are computers. II Some machines are instruments. III Some instruments are machines.