Bissoy.com
Doctors Medicines MCQs Q&A

If Sb, is the average bond stress on a bar of diameter d subjected to maximum stress t, the length of the embedment $$l$$ is given by

If Sb, is the average bond stress on a bar of diameter d subjected to maximum stress t, the length of the embedment $$l$$ is given by Correct Answer $$l = \frac{{{\text{dt}}}}{{4{{\text{S}}_{\text{b}}}}}$$

Related Questions

If Sb, is the average bond stress on a bar of diameter ‘d’ subjected to maximum stress ‘t’, the length of the embedment ‘l’ is given by
If the average bending stress is 6 kg/cm2 for M 150 grade concrete, the length of embedment of a bar of diameter d according to I.S. 456 specifications, is
The extension of a circular bar tapering uniformly from diameter $${{\text{d}}_1}$$ at one end to diameter $${{\text{d}}_2}$$ at the other end and subjected to an axial pull of P is _________ the extension of a circular bar of diameter $$\sqrt {{{\text{d}}_1}{{\text{d}}_2}} $$  subjected to the same load P.
Which one of the following is not correct about English bond? a) Bricks in one layer are laid on header bond and courses above and below are stretcher bond b) Bricks in one layer are laid on stretcher bond and courses above and below are header bond c) Every layer of bricks is laid on header and stretcher bond d) Bricks layer aligned such that vertical joint is continuous
A steel bar 2 m long, 20 mm wide and 10 mm thick is subjected to a pull of 2 kN. If the same bar is subjected to a push of 2 kN, the Poisson’s ratio of the bar in tension will be __________ the Poisson's ratio for the bar in compression.
Consider the following statements: The basic reason why shafts are made of steel and its alloys is: 1. The shaft is subjected to normal stress. 2. The shaft stress alternates with respect to time. 3. The shaft is subjected to pure compressive stress. 4. The shaft is subjected to the stress of constant intensity. Which of these statements are correct?
If d is the diameter of a bar, ft is allowable tensile stress and fb, is allowable bond stress, the bond length is given by
If d is the diameter of a bar, ft is allowable tensile stress and fb, is allowable bond stress, the bond length is given by
The length of the lap in a compression member is kept greater than bar diameter x (Permissible stress in bar / Five times the bond stress) or
Which of the following statements regarding an atom are correct? 1) If two atoms with similar ionization potential form a bond, then this bond will most probably be either covalent or metallic. 2) When atoms with different ionization potentials form a bond, the bond will be mainly ionic. 3) If the atom or molecule already has its outer shells completely full, then the bonding between the atoms or molecules will be a secondary bond when it solidifies.