Related Questions

The length of lap in tension reinforcement should not be less than the bar diameter × (actual tension / four times the permissible average bond stress) if it is more than
A 18 bar diameters
B 24 bar diameters
C 30 bar diameters
D 36 bar diameters
In a steam engine, one method of obtaining the earlier cut-off with a simple slide valve is by increasing the angle of advance of the eccentric while the throw of the eccentric, steam lap and exhaust lap are kept constant. This method will
A Cause withdrawing or throttling of steam
B Reduce length of effective stroke of piston
C Reduce maximum opening of port to steam
D All of these
The design stress, which is more than the damaging stress, is the least unit stress that will render a member unfit for service before the end of its normal life. The design stress factor or factor of safety indicates the margin between design stress and the __________ stress.
A Working
B Damaging
C Allowable
D None of these
A bond gets matured in 10 years . invested TK. 42,000 in this bond and received Tk. 105000 once the bond matured . If the bond was under simple interest . then what was the rate of interest per annum?
A 10%
B 12.5%
C 15%
D 7.5%
Ratio of permissible stress in direct compression and bending compression is
A Less than 1
B Between 1 and 1.5
C Between 1.5 and 2.0
D Greater than 2
In working stress design, permissible bond stress in the case of deformed bars is more than that in plain bars by
A 10%
B 20%
C 30%
D 40%
A two member committee comprising of one male and one female member is to be constitute out of five males and three females. Amongst the females. Ms. A refuses to be a member of the committee in which Mr. B is taken as the member. In how many different ways can the committee be constituted ?
A 11
B 12
C 13
D 14
Which one of the following species has the highest bond order, shortest bond length and maximum bond strength?
A O2
B O+2
C O-2
D O-22
When an open coiled helical compression spring is subjected to an axial compressive load, the maximum shear stress induced in the wire is (where D = Mean diameter of the spring coil, d = Diameter of the spring wire, K = Wahl's stress factor and W = Axial compressive load on the spring)
A $$\frac{{{\text{WD}}}}{{\pi {{\text{d}}^3}}} \times {\text{K}}$$
B $$\frac{{2{\text{WD}}}}{{\pi {{\text{d}}^3}}} \times {\text{K}}$$
C $$\frac{{4{\text{WD}}}}{{\pi {{\text{d}}^3}}} \times {\text{K}}$$
D $$\frac{{8{\text{WD}}}}{{\pi {{\text{d}}^3}}} \times {\text{K}}$$
When a bar of length '$$l$$' and diameter 'd' is rigidly fixed at the upper end and hanging freely, then the total elongation produced in the bar due to its own weight is (where w = Weight per unit volume of the bar)
A $$\frac{{{\text{w}}l}}{{2{\text{E}}}}$$
B $$\frac{{{\text{w}}{l^2}}}{{2{\text{E}}}}$$
C $$\frac{{{\text{w}}{l^3}}}{{2{\text{E}}}}$$
D $$\frac{{{\text{w}}{l^4}}}{{2{\text{E}}}}$$

Next steps