Bissoy.com
Doctors Medicines MCQs Q&A

In a doubly-reinforced beam if ‘c’ and ‘t’ are stresses in concrete and tension reinforcement, ‘d’ is the effective depth and ‘n’ is depth of critical neutral axis, the following relationship holds good

In a doubly-reinforced beam if ‘c’ and ‘t’ are stresses in concrete and tension reinforcement, ‘d’ is the effective depth and ‘n’ is depth of critical neutral axis, the following relationship holds good Correct Answer $$\frac{{{\text{mc}}}}{{\text{t}}} = \frac{{\text{n}}}{{{\text{d}} - {\text{n}}}}$$

Related Questions

A singly reinforced beam has breadth b, effective depth d, depth of neutral axis n and critical neutral axis n?. If fc and ft are permissible compressive and tensile stresses, the moment to resistance of the beam, is
A singly reinforced beam has breadth b, effective depth d, depth of neutral axis n and critical neutral axis n1. If fc and ft are permissible compressive and tensile stresses, the moment to resistance of the beam, is
Consider the following statements regarding stress in beam : 1. If a member is subjected to equal and opposite couples acting in the same longitudinal planes, the member is said to be in pure bending. 2. The internal stresses developed in the beam are known as flexural stresses. 3. There is an intermediate surface known as neutral surface, at which the stress is zero. 4. An axis obtained by intersection of the neutral surface and a cross-section is known as neutral axis. Which of the above statements are correct ? 
Below are given two sets, Set - I which gives modalities of operant conditioning and Set - II which provides the types of reinforcement, the types of responses (responses made or withheld) and the presence or absence of cue. Match the two sets and indicate your answer by choosing from the code : Set - I (Modalities of operant conditioning procedures) Set – II           (Conditions and contexts) (a) Reward training (i) Positive reinforcement, response made, with cue present (b) Escape training (ii) Positive reinforcement, response withheld with cue absent (c) Discriminated omission training   (iii) Positive reinforcement, response made with cue absent (d) Active avoidance   (iv) Negative reinforcement, response made with training (e) Punishment training (v) Positive reinforcement, response withheld with cue present   (vi) Negative reinforcement, response withheld with cue absent  
If the depth of actual neutral axis in a beam is more than the depth of critical neutral axis, then the beam is called
When the depth of the actual neutral axis in a beam is greater than the depth of the critical neutral axis, then the beam is called:
The stresses developed in concrete and steel in reinforced concrete beam 25 cm width and 70 cm effective depth, are 62.5 kg/cm2 and 250 kg/cm2 respectively. If m = 15, the depth of its neutral axis is
Consider the following statements with regards to the shear force diagram for the beam ABCD: 1. The beam ABCD is an overhanging beam having supports at A and D only. 2. The beam carries a point load of 20 kN at C. 3. The beam carries a concentrated load of 10 kN at the end B. 4. The beam is an overhanging beam having supports at C and D only. 5. The beam carries a uniformly distributed load of 70 kN over the left hand portion AC only. Which of the above statements are correct?
As per IS : 456-2000, the maximum spacing of shear reinforcement along the axis of the beam for vertical stirrups should be less than (where D is total depth of beam and d is effective depth of beam)
In WSM, if the critical depth of neutral axis is equal to k × d where d is effective depth of beam, then what is the value of k for steel 500 and concrete M25?