Related Questions

A diamond pointed chisel is used for cutting
A Flat surfaces
B Grooves
C Key-ways
D V-shaped grooves
The cutting edge of a chisel should be
A Hardened
B Tempered
C Hardened and tempered
D Case hardened
The obtuse angle, included between the chisel edge and the lip as viewed from the end of a drill, is called
A Helix or rake angle
B Point angle
C Chisel edge angle
D Lip clearance angle
The cross-section of a chisel is usually
A Rectangular
B Square
C Hexagonal
D Octagonal
The pyramidal peaks that form when several cirques chisel a mountain form three more sides are called
A horns
B cirques
C aretes
D medial moraines
A cold chisel is made of
A Mild steel
B Cast iron
C H.S.S.
D High carbon
Which of the following is not the value the key property will hold if the key is a function key?
A F8
B F2
C F9
D Left
When assigning a shortcut key to a symbol, you should always try to select a key or key combination that is:
A Unassigned
B Located on the ten-key pad section of your keyboard.
C Assigned to another task.
D From the same font family as the symbol.
A taper key which fits half in the key way of the hub and half in the key way of shaft, is known as
A sunk key
B flat saddle key
C hollow saddle key
D tangent key
When the material of key and shaft is same, and the width of key is one-fourth of the diameter of shaft (d), then length of key will be
A 0.8 d
B 1.2 d
C 1.57 d
D 1.8 d

Next steps