Bissoy.com
Doctors Medicines MCQs Q&A

A hole is of dimension φ = 9 ₊0⁺⁰∙⁰¹⁵ mm. The corresponding shaft is of dimension φ = 9 ₊0.001⁺⁰∙⁰¹⁰ mm. The resulting assembly has

A hole is of dimension φ = 9 ₊0⁺⁰∙⁰¹⁵ mm. The corresponding shaft is of dimension φ = 9 ₊0.001⁺⁰∙⁰¹⁰ mm. The resulting assembly has Correct Answer Transition fit

Related Questions

An Identity Card has the number ABCDEFG, not necessarily in that order, where each letter represents a distinct digit (1, 2, 4, 5, 7, 8, 9 only). The number is divisible by 9. After deleting the first digit from the right, the resulting number is divisible by 6. After deleting two digits from the right of original number, the resulting number is divisible by 5. After deleting three digits from the right of original number, the resulting number is divisible by 4. After deleting four digits from the right of original number, the resulting number is divisible by 3. After deleting five digits from the right of original number, the resulting number is divisible by 2. Which of the following is a possible value for the sum of the middle three digits of the number?
A double universal joint is used to connect two shafts in the same plane. The intermediate shaft is inclined at an angle of 20° to the driving shaft as well as the driven shaft. Find the maximum speed of the intermediate shaft if the driving shaft has a constant speed of 500 r.p.m.
A double universal joint is used to connect two shafts in the same plane. The intermediate shaft is inclined at an angle of 20° to the driving shaft as well as the driven shaft. Find the minimum speed of the intermediate shaft if the driving shaft has a constant speed of 500 r.p.m.
A double universal joint is used to connect two shafts in the same plane. The intermediate shaft is inclined at an angle of 20° to the driving shaft as well as the driven shaft. Find the maximum speed of the driven shaft if the driving shaft has a constant speed of 500 r.p.m.
A double universal joint is used to connect two shafts in the same plane. The intermediate shaft is inclined at an angle of 20° to the driving shaft as well as the driven shaft. Find the minimum speed of the driven shaft if the driving shaft has a constant speed of 500 r.p.m.
Consider two shafts connected with two gears as per the following options: 1. One on each shaft 2. Through an intermediate gear mounted on an intermediate shaft, and every shaft having one gear only 3. Through an intermediate gear mounted on an intermediate shaft, with the intermediate shaft having two gears, whereas the other shafts have one gear each Which of the above represent(s) a simple gear train?
Consider the following statements: In case of assembly of mating parts 1. the difference between hole size and shaft size is called allowance 2. in transition fit, small positive or negative clearance between the shaft and hole member is employable Which of the above statements is/are correct?
In an assembly of hole and shaft, smallest hole was having diameter of 49.98 mm and largest shaft was having diameter of 49.94 mm. Minimum clearance in mm will be
In an assembly of hole and shaft, smallest shaft was having diameter of 49.98 mm and largest hole was having diameter of 50.14 mm. Maximum clearance in mm will be
In an assembly of hole and shaft, largest shaft was having diameter of 50.18 mm and smallest hole was having diameter of 49.98 mm. Maximum interference in mm will be