Related Questions

The angle made by the face of the tool and the plane parallel to the base of cutting tool is called
A Rake angle
B Cutting angle
C Clearance angle
D Lip angle
As the cutting speed increases, the tool cutting forces
A Remain constant
B Increases
C Decreases
D First increases and then decreases
In oblique cutting system, the cutting edge of the tool
A May clear the width of the workpiece
B May or may not clear the width of the workpiece
C May not clear the width of the workpiece
D Should always clear the width of the workpiece
In oblique cutting of metals, the cutting edge of the tool is
A Perpendicular to the workpiece
B Perpendicular to the direction of tool travel
C Parallel to the direction of tool travel
D Inclined at an angle less than 90° to the direction of tool travel
In machining metal, cutting force at the cutting edge is measured by a
A Wattmeter
B Dynamometer
C Hydrometer
D Pyrometer
In metal cutting, use of low feeds and high cutting speeds is desired when the objective is
A High metal removal rate
B Dry machining
C Use of soft cutting tool
D Surface finish
The process of removing metal by a cutter which is rotated against the direction of travel of the workpiece, is called
A down milling
B up milling
C face milling
D end milling
The process of removing metal by a cutter which is rotated against the direction of travel of workpiece, is called
A Up milling
B Down milling
C Face milling
D End milling
The process of removing metal by a cutter which is rotated in the same direction of travel of workpiece, is called
A Up milling
B Down milling
C Face milling
D End milling
In sheet metal work, he cutting force on the tool can be reduced by
A Grinding the cutting edges sharp
B Increasing the hardness of tool
C Providing shear on tool
D Increasing the hardness of die

Next steps