Related Questions

In a milling operation, two side milling cutters are mounted with a desired distance between them so that both sides of a workpiece can be milled simultaneously. This set up is called
A Gang milling
B Straddle milling
C String milling
D Side milling
The type of tool used on milling machine and broaching machine is
A Single point cutting tool
B Two point cutting tool
C Three point cutting tool
D Multi-point cutting tool
The rated loads of lifting cranes, as percentage of tipping load at specified radius, for crawler-mounted and pneumatic tyre-mounted machines would be respectively
A 80 and 90
B 90 and 80
C 85 and 75
D 75 and 83
As the cutting speed increases, the tool cutting forces
A Remain constant
B Increases
C Decreases
D First increases and then decreases
In oblique cutting system, the cutting edge of the tool
A May clear the width of the workpiece
B May or may not clear the width of the workpiece
C May not clear the width of the workpiece
D Should always clear the width of the workpiece
In oblique cutting of metals, the cutting edge of the tool is
A Perpendicular to the workpiece
B Perpendicular to the direction of tool travel
C Parallel to the direction of tool travel
D Inclined at an angle less than 90° to the direction of tool travel
The angle made by the face of the tool and the plane parallel to the base of cutting tool is called
A Rake angle
B Cutting angle
C Clearance angle
D Lip angle
A machine P can print out one lakh books in 8 hours. Machine Q can print the same number of books in 10 hours while machine R can print them in 12 hours. All the machines are started at 9 A.M.While machine P is stopped at 11 A.M. and remaining two machines completed the work. Approximately at what at what time will the work time (to print one lakh books) be finished?
A 11.30 Am
B 12 Noon
C 12.30 Pm
D 11.35 am
A small factory with 3 machines has a job of stamping out a number of pan covers. The newest machine can do the job is 3 days, another machine can do it in 4 days, and the third machine can do it in 6 days. How many days will the factory take to do the job using all the machine?
A 1.333
B 4.333
C 6
D 13
A machine P can paint one lakh books in 8 hours; machine Q can print the same number of books in 10 hours while machine R can print them in 12 hours. All the machines started operating at 9 A. M. while machine P is stopped at 11 A. M. and the reamaining two machines completed the work. Approximately at what time will the work (to print one lakh books) be finished?
A 11:30 A. M
B 12:00 noon
C 12:30 P. M.
D 1:00 P. M.

Next steps