Related Questions

For the same terminal conditions and valve size, the pressure drop in a fully opened globe valve as compared to that in a gate valve is
A More
B Less
C Equal
D Either A or B; depends on the viscosity of the fluid
The valve overlap in four stroke petrol engines is approximately
A 30°
B 60°
C 90°
D 120°
stand next to the lamppost and face west ,walk 20 yards and then turn 90 degrees clockwise. Walk another 10 yards and then turn 45 degrees anticlockwise. Walk another 15 yards, reverse you direction and walk 5 yards back. Turn 135 degrees clockwise and walk another 10 yards . In which direction are you now facing?
A West
B East
C South
D North
In a four stroke engine for each crankshaft revolution, the camshaft revolves
A One half turn
B One turn
C Two turns
D Four turns
The timing belt is attached to the camshaft pulley and
A Timing belt drive pulley
B Distributor
C Radiator fan pulley
D Alternator pulley
The mixing vat in a factory receives liquid ingredients through six separate value--- labeled R.S.T.U,Y and Z -- each of which has exactly two settings: open and closed.The mixing vat operator must ensure that each valve is set open or closed according to the following conditions: If T is open, both S and Z must be closed, R and Z cannot both be closed at the same time; If Y is closed, Z must also be closed;S and U cannot both be open at the same time. Which of the following, if given to the mixing vat operator as an instruction, would not determine the setting of any other valve ?
A S must be open
B T must be open
C U must be open
Main gas valve in a gaseous fuel burner is a __________ valve.
A Gate
B Butterfly
C Globe
D None of these
In Meyer's expansion valve, the expansion valve is driven by an eccentric having an angle of advance from
A 50° - 60°
B 60° - 70°
C 70° - 80°
D 80° - 90°
In Meyer's expansion valve, the main valve is driven by an eccentric having an angle of advance from
A 10° - 15°
B 15° - 25°
C 25° - 30°
D 30° - 40°
In a steam engine, the earlier cut-off with a simple slide valve may be obtained by increasing the steam lap and the angle of advance of the eccentric but keeping constant the travel and lead of the valve, this method will
A Cause withdrawing or throttling of steam
B Reduce length of effective stroke of piston
C Reduce maximum opening of port to steam
D All of these

Next steps